Dodge Ram Mirror Set

Frequently bought together

Warranty & Shipping
How-To & Tools
Product Reviews
Vehicle Fit

Part Details

  • Mirror Signal Type:   Signal & Clearance Light
  • Mirror Set Includes:
      (1) Passenger Side Mirror
      (1) Driver Side Mirror
  • Mirror Operation:   Power
  • Mirror Color / Finish:   Gloss Black
  • Mirror Heating Type:   Heated
  • Side View Mirrors Features & Benefits:
      Backed by our limited lifetime warranty
      Direct-fit replacement
      Manufactured with high quality materials
      Mirror glass meets or exceeds OEM standards
      OE finish to match the original

This replacement mirror PAIR is just what you need to get your Dodge Ram truck in good looking form again!

This mirror PAIR features the following specifications:

  • Comes as a PAIR
    • Fits both the LH (Driver) & RH (Passenger) Sides
  • Power
  • Heated
  • Signal
  • Clearance Light
  • Folding - Manual
  • Textured black grained finish with
    • Gloss Black Head
      • Can be painted to any color desired or installed as is
  • Replaces dealer part number: 1FX371XRAD, 1FX361XRAD
  • Direct replacement
  • Built to strict quality control standards
  • No Memory Function

This mirror pair makes a great replacement and has good cost savings over a dealer mirror set.

Special Note:

Replacement mirrors will only work for vehicles with the same exact options. If you do not have the options listed in specifications, the mirrors may not function properly.

Item Condition: New

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

  1. step : Beginning the Repair (0:00)
    • This is Part 1 of a two part video
    • Please consult Part 2 for further instructions
    • Perform the steps outlined in Part 2
  2. step : Removing the Door Panel (1:13)
    • Remove the screws in the door handle with a Phillips screwdriver or a 7mm socket and ratchet
    • Remove the door handle bezel
    • Remove the T20 clips along the edge of the door panel
    • Pull the door panel out
    • Pry up the master switch panel
    • Disconnect the switch wiring harnesses
    • Lift the door panel up and off
  3. step : Removing the Side View Mirrors (2:15)
    • Disconnect the mirror wiring harness
    • Remove the three 10mm nuts from the mirror
    • Remove the mirror
  4. step : Installing the New Driver Side View Towing Mirror (2:49)
    • Insert the towing mirror into place
    • Tighten the three 10mm nuts to the mirror
    • Connect the mirror wiring harness
  5. step : Removing the Driver Side Dash Panels (4:03)
    • Remove the two Phillips screws from the lower dash panel beneath the steering wheel
    • Remove the lower dash panel
    • Remove the side dash panel
    • Remove the kick panel
    • Remove the two T20 Torx screws from the dead panel
    • Remove the dead panel
  6. step : Preparing the Folding Option Switch (5:24)
    • Disconnect the new folding switch connecter from its switch
    • Drill a hole in the dead panel with a 1/4" drill bit
    • Push the connecter into the dead panel to make sure it fits
  7. step : Connecting the Ground to a Ground Bolt (5:55)
    • Mark the each mirror wire to identify them
    • Feed the wires through the dead panel's positioning space
    • Wire-tie the connector to the dead panel slot
    • Loosen the ground bolt with a 10mm wrench
    • Insert the wiring harness ground into place
    • Tighten the 10mm ground bolt
  8. step : Connecting the Folding Option Wire to a Power Source (7:08)
    • Find the switched 12 volt power source wire (Blue wire with a purple stripe)
    • Insert and inline wiretap to the 12 volt wire
    • Hold the wiretap in place with pliers
    • Insert the mirror wire into the wiretap
    • Squeeze the wiretap tightly to secure the mirror wire
  9. step : Preparing the Passenger Side for the Folding Option Wire (8:44)
    • Pull straight out on the sides of the lower passenger dash panel to remove it
    • Open the glove box and pull the sides to remove it
    • Pull back firmly on the kick panel and pull up on the carpet trim to remove it
    • Remove the two T20 Torx screws from the door
    • Pry off the rubber boot and disconnect the wiring harness
    • Feed the rubber boot out through the door
    • Remove the tape and disconnect the plastic duct from the rubber boot
  10. step : Routing the Power Folding Option Wire to the Passenger Side (11:29)
    • Rout the wire through the center dash to the passenger door
    • Insert the behind the weatherstrip
    • Tape the wire to a screwdriver and pull it through the rubber boot
    • Connect the passenger side wire
  11. step : Testing the Power Folding Option (13:21)
    • Plug in the mirror folding switch
    • Turn on the vehicle
    • Press the switch to fold the mirrors

Tools needed for replacement:

    Drills, Drill Bits & Related

  • Drill
  • 1/2 Inch Drill Bit

  • Materials, Fluids, and Supplies

  • Electrical Tape
  • Duct Tape
  • Wire Ties

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 7mm Socket
  • 10mm Socket

  • Star Drivers & Sockets

  • T20 Driver

There are no reviews for this item.
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.

Fits the following Makes:

Year Make Model Description
2009-2010Dodge Ram 1500 Truck Dodge Ram 1500 Truck Power Heated Signal & Clearance Light Gloss Black Mirror Set
2010Dodge Ram 2500 Truck Dodge Ram 2500 Truck Power Heated Signal & Clearance Light Gloss Black Mirror Set
2010Dodge Ram 3500 Truck Dodge Ram 3500 Truck Power Heated Signal & Clearance Light Gloss Black Mirror Set
2011Ram 1500 Truck Ram 1500 Truck Power Heated Signal & Clearance Light Gloss Black Mirror Set
2011Ram 2500 Truck Ram 2500 Truck Power Heated Signal & Clearance Light Gloss Black Mirror Set
2011Ram 3500 Truck Ram 3500 Truck Power Heated Signal & Clearance Light Gloss Black Mirror Set
Only 4 left in stock
Part 1AMRP00607
In Stock

Orders must be placed by 2pm ET
Delivery options for:

Estimated Arrival Cost

Deliveries made to PO Boxes and FPO may take longer. See our Shipping & Delivery for more information.