O2 Oxygen Sensor Walker Products 250-24736 - WKEOS00154

Walker Products Oxygen Sensor: 250-24736

Walker Products, an ISO 9001-2008 / TS16949 certified company, specializes in the manufacturing and distribution of Fuel System Components and Automotive Engine Management products. Walker is committed to meeting or exceeding OEM or equivalent standards and specifications. This effort is backed by Walker's own manufacturing, product management and engineering expertise.

Specifications:

• Brand New Walker Oxygen Sensor
• Direct Fit
  • Correct Connector No cutting or splicing
• Downstream Sensor
• 4 wire configuration
• Built and tested to strict quality control standards

Note: For clarification purposes:

• Upstream location is between the catalytic converter and the engine
• Downstream location is between the catalytic converter and the tailpipe

Install note:

You may be required to reset the vehicle computer after installation of this part.

Our electrical and electronic parts are subject to strict quality control testing. Please ensure proper diagnosis of this item before purchasing as the item cannot be returned once installed or plugged in.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the O2 Sensor (0:49)

• Jack up and secure the vehicle on jack stands
• Disconnect the O2 sensor connector
• Remove the O2 sensor with an O2 socket or 22mm wrench

step : Installing the O2 Sensor (1:55)

• Remove the cap from the new sensor
• Install the sensor into the threads as far as possible by hand
• Tighten the O2 sensor with a 22mm wrench
• Connect the electrical connector