Dodge Dakota Durango Steering & Suspension Kit 10 Piece Set

Our steering and suspension components come pre-greased, sealed for long life, and do not require the extra maintenance typically required by greasable versions.

Application-specific, with no modifications required.

Made from higher quality materials than the competition. Built to have a longer life in any environment or road conditions.

By the same factories that the OEMs use.

Carefully assembled to include all of the parts you need, saving time and money.

Item Condition: New

Attention California Customers:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

Note: When replacing steering components, it is recommended to have a professional alignment performed on the vehicle afterwards. This will ensure proper tracking and even tire wear.

step : Removing the Wheel (0:47)

• Loosen the lug nuts
• Raise and support the vehicle
• Remove the lug nuts
• Pull off the wheel

step : Removing the Outer Tie Rod (1:14)

• Soak the tie rod jam nut and the other tie rod nut in rust penetrant
• Loosen the jam nut with a 24mm wrench
• Remove the 21mm nut from the outer tie rod
• Strike the wheel spindle with a hammer to release the outer tie rod
• Pull the tie rod down out of the wheel spindle
• Twist off the tie rod, counting how many turns it takes to remove
• Hold the inner tie rod with locking pliers
• Mark the jam nut position with a marker
• Twist off the jam nut with a 24mm wrench, counting how many turns it takes to remove

step : Installing the Outer Tie Rod (5:25)

• Mark the new jam nut
• Twist on the new jam nut the same number of turns it took to remove the old one
• Twist on the outer tie rod the same number of turns it took to remove the old one
• Insert the outer tie rod stud into the wheel spindle
• Fasten the 22mm nut onto the outer tie rod
• Tighten the 22mm nut to 63 foot-pounds of torque
• Tighten the new jam nut with a 22mm wrench
• Grease the tie rod fitting until the boot swells

step : Installing the Wheel (7:04)

• Lift the wheel into place
• Start the lug nuts
• Lower the vehicle to the ground
• Tighten the lug nuts to 110 foot-pounds