Description
Warranty & Shipping
How-To & Tools
Product Reviews
Q&A
Vehicle Fit

Part Details

  • Regulator Option:   with Motor
  • Operation:   Power

This replacement power window regulator is just what you need to get your vehicle in good shape again!

Specifications:

  • LH (Driver Side) REAR DOOR
  • Replaces dealer part number: 5065473AC
  • Power operation
  • Includes power window motor
  • Direct replacement
  • Built to strict quality control standards

This power window regulator makes a great replacement and has good cost savings over a dealer unit.

Please Note:

This window regulator is a high quality aftermarket part that meets or exceeds the performance of the original. It has been subjected to extensive testing and quality control standards. That is why we offer this regulator with our superior warranty!

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Door Panel (0:50)
    • Pry out the four push pins around the panel's sides
    • Remove the Phillips head screws along the bottom of the panel
    • Pry down the trap door behind the door handle and below the door pull
    • Remove the two Phillips screws
    • Slide the panel up and off of the door lock
    • Slide the latch rod out of the door handle
    • Disconnect the window switch connector
  2. step : Removing the Window Regulator (2:36)
    • Release the water shield adhesive with a razor
    • Carefully peel off the water shield
    • Connect the window switch electrical connector
    • Roll down the window
    • If the window does not roll down with the switch, cut the regulator cables
    • Disconnect the window switch electrical connector
    • Loosen the two 10mm bolts from the window rail
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Remove the 10mm bolt at the bottom of the door pull support
    • Loosen the 10mm bolt at the top of the door pull support
    • Pull out the door pull support
    • Disconnect the window motor electrical connector
    • Remove the 10mm bolt from the front of the regulator
    • Loosen the remaining two 10mm bolts from the regulator
    • Pull the regulator out of the door
  3. step : Installing the Window Regulator (6:14)
    • Slide the regulator into the door
    • Hang the regulator by its bolts
    • Tighten the two 10mm bolts for the regulator
    • Install the 10mm bolt for the front of the regulator
    • Connect the window motor electrical connector
    • Remove the painter's tape from the window
    • Lower the window onto the rail
    • Tighten the two 10mm bolts that hold the window to the rail
    • Hang the door pull support bracket by its top bolt
    • Tighten the top door pull support bolt
    • Install the bottom door pull support bolt
    • Line up the watershield
    • Press on the water shield adhesive
    • Tape the water shield into place if necessary
  4. step : Installing the Door Panel (8:33)
    • Connect the window switch connector
    • Connect the latch rod out of the door handle
    • Slide the door panel up into place
    • Press in the door panel clips
    • Tighten the three Phillips screws to the panel
    • Close the trap doors
    • Press on the four push pins to the door panel

Tools needed for replacement:

    General Tools

  • Razor Blade / Gasket Scraper

  • Materials, Fluids, and Supplies

  • Painter's Tape

  • Ratchets & Related

  • Ratchet
  • Torque Wrench
  • Socket Extensions

  • Screwdrivers & Related

  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

There are no reviews for this item.
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Year Make Model Description
2005-2010Chrysler 300 Chrysler 300 Rear Power Window Regulator with Motor Driver Side Dorman 748-546
2006-2010Dodge Charger Dodge Charger Rear Power Window Regulator with Motor Driver Side Dorman 748-546
2005-2008Dodge Magnum Dodge Magnum Rear Power Window Regulator with Motor Driver Side Dorman 748-546
Only 2 left in stock
Part #: 1AWRG01746


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

Dorman
Brand #: 748-546

How-to Video:

(09:35 min)