This replacement taillight circuit board is just what you need to get your vehicle in good working form again!

Specifications:

  • Fits the RH (Passenger Side)
  • Replaces dealer part number: 12335927
  • DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
  • Direct replacement for either side
  • Built to strict quality control standards

This taillight circuit board makes a great replacement and has good cost savings over a dealer unit.

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

  1. step : Removing the Taillight Connector Plate (0:52)
    • Remove the T30 bolts from the taillight.
    • Pull the taillight out.
    • Pull the clip on the harness free from the assembly.
    • Pry back the tabs and pop the plate out.
    • Disconnect the harness.
  2. step : Replacing the Taillight Connector Plate (2:43)
    • Put the two double filament bulbs into the top and bottom socket on the new connector plate.
    • Put the single filament in the center spots on the new connector plate.
    • Push the connector plate back into the taillight.
    • Connect the harness.
    • Clip the harness back to the assembly.
    • Push the taillight into place.
    • Replace the T30 bolts.

Tools needed for replacement:

    Torx Drivers & Sockets

  • T30 Torx Driver

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
1
0
0
0
0
Perfect match
Turn out that I didn’t need. Contacted customer service and they refunded me and I didn’t even have to return.Great service I’ll be back for all orders needed.
November 13, 2017
Purchased
8 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1997-2005 Chevy Venture Tail Light Circuit Board Passenger Side
  • 1997-2004 Olds Silhouette Tail Light Circuit Board Passenger Side
  • 1999-2004 Pontiac Montana Tail Light Circuit Board Passenger Side
  • 2005 Pontiac Montana Base Model Tail Light Circuit Board Passenger Side
  • 1997-1998 Pontiac Trans Sport Tail Light Circuit Board Passenger Side

This part replaces:

  • Partslink GM2817100
  • OE # 12335927
  • TYC 11-5131-20
  • DEPO 17-332-1931RB
Part #: 1ALTL01559

How-to Video:

(05:31 min)