Ford Performance Lighting Kit

Specifications:

• Comes as a Set of 4
  • Fits both LH (Driver Side) & RH (Passenger Side)
• Includes clear lens composite headlights
• Includes diamond style parking lights
• Bulbs not included

Direct fit replacement for OEM assembly

Uses same wiring as original assembly.  No cutting or splicing required.

Meets federal regulations for on-road use

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

Bulb Note:

These lights do not include bulbs.  If you happen to receive a product with bulbs, the bulbs are for testing and not covered under our warranty.  Our warranty applies to the light assembly only.

step : Changing the Headlight Bulbs (1:05)

• Reach in to the back of the light and twist the ring counter clockwise
• Pull it off to pull the bulb out
• Hold the collar back and pull the bulb free
• Push a new bulb in and snap it back into the ring
• Push the bulb back into the assembly and twist clockwise

step : Removing the Headlight Assembly (2:34)

• Use an awl to pull the arms out and up on the side of the tabs holding in the headlight
• Hook the awl into the top of the clip and force it up and out. Repeat on the other side of the light
• Remove the clip down past the headlight wiring harness. Remove the clip by pressing in the wings on either side
• Pull the headlight out
• Disconnect the harnesses to free the light

step : Installing the New Headlights (6:24)

• Adjust the lower clip to match the clip on the old headlight
• Measure the top adjustors to make sure they are the same distance from the light
• Reconnect the light harnesses
• Line up the light and push it in to connect it
• Push the clips on the back, back into place

step : Adjusting the Headlight (8:43)

• Set the light to your states standards
• The right Phillips screw adjusts the light left to right
• The left Phillips screw adjusts the light up and down