Ford Lincoln Mercury Rear Passenger Side Door Lock Actuator with Bracket - 1ADLA00105

This is a power door lock actuator that mounts inside the door. It is designed to REPLACE a broken or missing unit.

Specifications:

• Fits RH (Passenger Side) REAR
• Power Door Lock Actuator with Bracket
• Replaces dealer part numbers: F5DZ-54265-94AA, F8AZ-54265-94AA, F5DZ5426594AA, F8AZ5426594AA
• Electrically operated, not vacuum
• Correct electrical connection
• Anodized steel housing resists corrosion

This power door lock actuator is built to strict quality control standards. It is a great replacement and has substantial cost savings over a dealer unit.

Our electrical and electronic parts are subject to strict quality testing.

Parts cannot be returned after they have been installed. Contact us with any questions before installing the parts.

Item Condition: New

Attention California Customers:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Remove the door panel (1:12)

• Remove the two Phillips screws from the door pull
• Use a flat blade screwdriver to pry out the door handle bezel.
• Use a putty knife to carefully pry off the door panel and unclip the clips securing it.
• Pull off the panel and unplug all the wiring

step : Remove the door lock actuator (3:45)

• Carefully pull aside the plastic water shield
• Drill out the rivets securing the door lock actuator.
• Unclip the lock rods and unplug the wiring harness
• Transfer the mounting bracket and dust cover to the new lock actuator

step : Install the new door lock actuator (5:40)

• Use a couple coarse threaded bolts rather than rivets to re-install the door lock actuator
• Plug in the wiring harness and lock rods.
• Test your connections to make sure the doors lock and unlock properly.

step : Re-install the door panel (7:00)

• Put the water shield back into place.
• Reconnect the speaker and light.
• Thread the wiring harness back into place.
• Clip the door panel back on.
• Re-install the door handle bezel.
• Plug in the control panel.
• Bolt back in the door handle pull using your Phillips screwdriver.