Replaces
This part doesn’t fit a . Select from parts that fit.
1A Auto Lifetime Warranty
Frequently bought together
Complete Repair in One Purchase - Stop searching for parts individually and complete your repair with a customized kit or set from DIY Solutions.
High-Quality Parts from Trusted Brands - DIY Solutions' kits and sets are selected from the best automotive brands and include hard-to-find and even obsolete parts you may need for your vehicle.
Guaranteed Fit - DIY Solutions ensures its selected parts are quality-tested to guarantee fit and function.
Install Tip: Keep & reuse your original hardware, new hardware is not included with this item.
Item Condition:
New
Attention California Customers:
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to either replace or install a license-plate bracket on this 2003 GMC Envoy XL.
The first thing you want to do is remove what's left of your old license-plate bracket, if anything. You may have bolts or screws or something that fastens it. Whatever your fastener is, just remove it. In our case, it's clips where you pry out the center and they pull free.
You can see that we had an original license-plate holder on there. The new one from 1A Auto is exactly the same. It's going to all mount the same. I'm just going to put the old one back on, but obviously, if yours has gotten torn off, you'll already have the holes here, and you may already have the fasteners. Ours was held on with this style clip. If you're going to have to hold it on with the clips again, you'll need to drill a hole that's just big enough for the clip to go through. Then as you push the clip in, it widens these legs out and holds. The other possibility you could do is just a course-thread bolt with a washer. In that case, you would want to drill a hole that's slightly smaller than the bolt, and then put it in. Then what you would do is put it on here and just basically place it wherever you might want it. You can go a little higher, go a little lower. The bottom poles do have to be on the bumper cover, though. You could just line those up just above, but put it where you want it height-wise. Try and make sure it's level, and then try to center it kind of using the GMC logo. What I would normally do is I'd drill one hole. I'd put a fastener into the hole and get it held pretty steadily. So you can imagine we've drilled one hole, put a fastener in, and then I'd make sure it's nice and level again. Then I'd drill the second hole, and again, put a fastener in. These things you've got to pull out far enough so the wings can squeeze together. Then just repeat the process for the two lower fasteners.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
Tools used
