Chevrolet Buick Pontiac Olds Blower Motor Resistor Wells Vehicle Electronics DR783

Our electrical and electronic parts are subject to strict quality testing.

Parts cannot be returned after they have been installed. Contact us with any questions before installing the parts.

Left Hand Drive Note:

“All of our auto parts are intended for Left Hand Drive USDM vehicles and might not have been tested on Right Hand Drive platforms. If your vehicle is Right Hand Drive, please do your research prior to making a purchase to ensure the part is correct for your specific vehicle.”

Item Condition: New

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

step : Access the blower motor resistor (1:10)

• Remove the lower vanity panel using a pair of needle nosed pliers to remove the push clips.
• Unplug the courtesy light.

step : Remove the blower motor resistor (2:06)

• Remove the wiring harness bracket with your 5 mm socket and ratchet.
• Use your T20 Torx driver to remove the three screws around the motor.
• Pull the motor down.
• Unplug the wiring harness from the motor.
• Unplug the resistor from the harness.
• Unbolt the now unplugged resistor with you 7/32 inch socket and ratchet with a U joint extension and remove it.

step : Install the new blower motor fan speed resistor (7:33)

• Use your 7/32 inch socket, ratchet and U joint extension to bolt it back in.
• Install the blower motor and plug everything back in.
• Bolt the motor back in with your T20 Torx driver and ratchet.
• Install the harness bracket with your 5mm socket and ratchet.
• Test and replace the vanity cover and courtesy light.