2011 Ford F350 Super Duty Truck Fog / Driving Light Pair

These replacement fog lights are just what you need to get your vehicle in good looking form again!

Specifications:

• Comes as a PAIR
  • Fits both LH (Driver Side) and RH (Passenger Side)
  • Bumper Mounted
• Replaces dealer part numbers: BC3Z-15200-A, BC3Z-15201-A, BC3Z15200A, BC3Z15201A
• DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
• Direct replacements
• Built to strict quality control standards

These fog lamps are great replacements and have good cost savings over fog lights from the dealer.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

Your DIY Solution—Complete Repair in One Purchase

Do you need an assortment of parts to complete a repair? Stop searching for parts individually and complete your repair in a single purchase with a customized kit or set from DIY Solutions.

High-Quality Parts From Trusted Brands

Parts in DIY Solutions' kits and sets are selected from the best automotive brands and include hard-to-find and even obsolete parts you may need for your vehicle.

Guaranteed Fit

DIY Solutions ensures its selected parts are quality-tested to guarantee fit and function.

Direct fit replacement for OEM assembly

Uses same wiring as original assembly.  No cutting or splicing required.

Meets federal regulations for on-road use

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

step : Removing the Fog Light (0:45)

• Remove the four 13mm bolts from the fender bracket
• Pull out the fender bracket
• Remove the three 8mm bolts from the back of the fog light
• Disconnect the fog light wiring connector
• Pull the fog light and bezel out from behind the bumper

step : Removing the Fog Light from the Bezel (2:01)

• Remove the four 13mm nuts that hold the bezel to the fog light
• Pull the bezel off the front of the fog light

step : Installing the Fog Light from the Bezel (3:12)

• Slide the fog light bezel onto the fog light
• Fasten the four 13mm nuts that hold the bezel to the fog light

step : Installing the Fog Light (3:29)

• Place the fog light into the bumper from behind
• Install the three 8mm bolts that hold the fog light to the bumper
• Connect the fog light electrical connector
• Lift the fender bracket into place
• Insert the four 13mm bolts into the fender bracket