This replacement Tail light is just what you need to get your Honda CR-V in good looking form again!

Specifications:

  • RH (Passenger Side)
  • Replaces dealer part number: 33501-SCA-A00, 33501SCAA00
  • DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
  • Direct replacement
  • Built to strict quality control standards
  • Fits vehicles that were built in the U.K. (United Kingdom) only

Note: The first digit of your vehicle identification number (VIN) determines where it was built:

  • J = Japan
  • S = U.K.

The (VIN) number can be found on your vehicle registration or under the windshield near the driver's side front "A" pillar post.

We have noticed that there are many inferior quality Tail lights on the market. We have researched other tail light manufacturers and are only selling what we believe to be the highest quality, best fitting, aftermarket tail lights available. So don't be fooled by cheaper made imitation tail lights. Go with superior quality!

This Honda CR-V taillamp makes a great replacement and has good cost savings over a dealer Tail light.

Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Uses same wiring as original assembly.  No cutting or splicing required.

DOT and SAE Compliant

Meets federal regulations for on-road use

Part Details

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

  1. step : Removing the Taillight Assembly (0:43)
    • Pry out the two plugs to uncover the bolts.
    • Remove the 8mm bolts.
    • Pull the taillight out.
  2. step : Replacing a Bulb (1:49)
    • Twist the sockets out counterclockwise.
    • Pull the bulb straight out.
    • Push a new bulb in.
    • Twist the socket back in.
  3. step : Removing the Taillight Assembly Continued (2:22)
    • Remove the Panel, table, spare tire and the panel below the spare tire.
    • Remove the clips on the panel near the bumper. Remove the Panel.
    • Remove the Phillips screw by the taillight.
    • Remove the jack cover. Remove the jack.
    • Pry out the inner panel.
    • Disconnect the taillight harness.
    • Pull the grommet out and pull the light off.
  4. step : Replacing the Taillight Assembly (4:49)
    • Push in the harness.
    • Push the rubber grommet in.
    • Line-up and push the light into place.
    • Reconnect the harness.
    • Replace the inner panel.
    • Replace the Phillips screw.
    • Replace the jack and the jack cover.
    • Replace the lower panel.
    • Replace the Spare tire, panels and table.
    • Replace the two 8mm bolts.
    • Replace the two plugs.

Tools needed for replacement:

    Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 8mm Socket

5.0 / 5.0
3 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
3
0
0
0
0
Honda tail light was perfect fit and works great!
My Honda CR-V tail light purchased from 1A Auto fit my car perfectly and works great! The video 1A Auto had made it easy to put on myself which saved me a lot of money. The rep. I talked to was very knowledgeable and asked for my VIN # so we could determine WHERE my car was made and get the right part. I would have gotten that wrong if it hadn't been for him. Thanks 1A Auto! Joe
October 23, 2017
Purchased
9 months ago
Excellent quality, perfect fit, easy installation, great instructional video. Thanks!
October 10, 2017
Purchased
9 months ago
Worked Perfectly.
The detailed video 1A made for installation earned my business. And on the phone they assured me that it would match perfectly - which it did. Made a little driving mishap go away.
April 4, 2017
Purchased
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2002-2004 Honda CR-V (UK Built Models (1st VIN Digit S)) Tail Light Passenger Side

This part replaces:

  • Partslink HO2819127
  • Hollander 166-59387AR
  • OE # 33501SCAA00
  • TYC 11-6045-00
Only 1 left in stock
Part #: 1ALTL00450

How-to Video:

(08:34 min)