Replaces

2001-06 Hyundai Elantra Window Regulator Dorman 741-264 - 1AWRG01826

Part Details

  • Regulator Option: with Motor
  • Operation: Power

This replacement window regulator is just what you need to get your vehicle in good working form again!

Specifications:

  • RH (Passenger Side) FRONT DOOR
  • Power operation
  • Includes the Power Window Motor
  • Replaces dealer part number: 82402-2D010, 824022D010
  • 100% tested prior to leaving the factory
  • Direct replacement
  • Built to strict quality control standards

This window regulator makes a great replacement and has good cost savings over the dealer part.

Please Note:

This window regulator is a high quality aftermarket part that meets or exceeds the performance of the original. It has been subjected to extensive testing and quality control standards. That is why we offer this regulator with our superior warranty!

Item Condition: New

California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Door Panel (0:42)
    • Pry off the trim piece at the front top corner of the door panel with a flat blade screwdriver
    • Pry off the two trim covers on the side of the door with a flat blade screwdriver
    • Pry off the trim pieces underneath the door pull with a flat blade screwdriver
    • Remove the two Phillips screws at the bottom, back, and side of the door panel
    • Remove the Phillips head screw inside the door handle
    • Remove the two Phillips head screws underneath the door pull
    • Remove the door handle bezel
    • Pry out the door panel by hand
    • Lift the door panel up and off
    • Disconnect the door lock wiring harness
    • Disconnect the window switch wiring harnesses
    • Disconnect the courtesy light wiring harness
    • Carefully peel off the water shield
  2. step : Removing the Window Motor (3:44)
    • Disconnect the window motor lead
    • Loosen the three 10mm bolts that hold the window motor
    • Remove the window motor
  3. step : Removing the Window Regulator (4:10)
    • Remove a Phillips head screw from the door handle
    • Disconnect the latch cables from the door handle from the blue and pink clips
    • Remove the door handle
    • Remove the two 10mm bolts from the window
    • Raise the window by hand
    • Remove the window
    • Remove the four 10mm bolts from the regulator
    • Pull the window regulator out through the door
    • Remove the clips from the wiring harnesses with pliers
  4. step : Reinstalling the Regulator (7:03)
    • Push the regulator into the door with the door lock cables over the regulator
    • Line up the clips on the regulator onto the door
    • Attach the clip to the lock cables
    • Insert the four 10mm bolts into the regulator
    • Lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
  5. step : Reinstalling the Motor (10:08)
    • Insert the window motor
    • Tighten the three 10mm bolts that hold the window motor
    • Connect the window motor lead
  6. step : Reinstalling the Door Panel (10:46)
    • Put the water shield into place
    • Insert the door handle
    • Connect the latch cables to the door handle
    • Connect the door lock wiring harness
    • Connect the window switch wiring harnesses
    • Connect the courtesy light wiring harness
    • Lift the door panel into place
    • Push in the door panel clips
    • Insert and tighten the two Phillips screws at the bottom, back, and side of the door panel
    • Push on the door handle bezel
    • Insert and tighten the Phillips head screw inside the door handle
    • Insert and tighten the two Phillips head screws underneath the door pull
    • Push in the trim piece at the front top corner of the door panel
    • Push in the two trim covers on the side of the door
    • Push in the trim pieces underneath the door pull

Tools needed for replacement:

    General Tools

  • Razor Blade / Gasket Scraper

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

Year Make Model Description
2001-2006Hyundai Elantra Hyundai Elantra Front Power Window Regulator with Motor Passenger Side Dorman 741-264

This part replaces:

  • Hollander 125-58859R
  • Dorman 741-264
  • OE # 824022D010
Only 2 left in stock
Part #: 1AWRG01826


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

Dorman
Brand #: 741-264

How-to Video:

(13:51 min)