2000-04 Jeep Grand Cherokee Front Door Lock Actuator & Integrated Latch Pair DIY Solutions

Your DIY Solution—Complete Repair in One Purchase

Do you need an assortment of parts to complete a repair? Stop searching for parts individually and complete your repair in a single purchase with a customized kit or set from DIY Solutions.

High-Quality Parts From Trusted Brands

Parts in DIY Solutions' kits and sets are selected from the best automotive brands and include hard-to-find and even obsolete parts you may need for your vehicle.

Guaranteed Fit

DIY Solutions ensures its selected parts are quality-tested to guarantee fit and function.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

step : Removing the Door Panel (1:09)

• Pry off the trim piece inside the door pull with a flat blade screwdriver
• Pry off the door handle bezel with a flat blade screwdriver
• Pry off the window switch with a flat blade screwdriver
• Disconnect the window switch wiring harness
• Remove the two 7mm bolts inside the door pull
• Pry off the door panel by hand

step : Accessing the Door Lock Mechanism (2:58)

• Remove the 10mm bolt from the door handle
• Pull the door handle forward and out
• Pull of the latch and lock rod clips
• Pull the latch rod and lock rod out of the door handle
• Peel back the water shield

step : Removing the Door Lock Mechanism (3:58)

• Pull the lock knob rod out of the yellow clip
• Remove the three T30 Torx bolts from the lock mechanism
• Pull the lock mechanism down, while keeping the latch rods from falling into the door
• Separate the latch and lock rods from the lock mechanism
• Disconnect the wiring harnesses from the lock mechanism
• Pull the lock mechanism out of the door

step : Separating the Door Lock Actuator (5:43)

• Carefully remove the three T10 Torx bolts that hold the actuator to the lock mechanism
• Pull the actuator away from the lock mechanism

step : Connecting the New Door Lock Actuator (6:18)

• Push the door lock actuator shoe into the lock mechanism
• Twist the actuator into place
• Line up the actuator and lock mechanism gear teeth
• Insert the three T10 Torx bolts into the actuator

step : Reinstalling the Door Lock Mechanism (7:11)

• Attach the rod with the white wrap to the upper lock clip
• Attach the rod with the yellow wrap to the lower lock clip
• Attach the wiring harnesses to the lock mechanism
• Push the mechanism into place
• Start the three T30 Torx screws by hand
• Reconnec the lock knob rod to the yellow clip
• Test that the door lock works

step : Reinstalling the Door Handle (9:06)

• Put the water shield on
• Attach the latch rods to the door handle using the clips
• Push the door handle into place
• Insert the 10mm bolt into the door handle

step : Reinstalling the Door Panel (10:41)

• Pull the wiring harnesses through their cavity
• Lift the door panel into place
• Push the door panel clips in
• Connect the window switch wiring harness
• Push the door handle bezel into place using the locating tab
• Insert the two 7mm bolts into the door pull
• Push the trim piece into the door pull
• Make sure the door is unlocked