Ford Lincoln Shifter Lever Ford OEM 4L3Z-7210-BAA

Specifications:

• Brand New Ford Automatic Transmission Shifter Lever
• Includes overdrive button
• Original equipment part

Genuine original equipment part (OEM) that was factory installed on your vehicle by the manufacturer.

Item Condition: New

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

step : Removing the Steering Column Cover (1:24)

• Press the detent ball in the cylinder by inserting a pick into the bottom of the column
• Remove the three Phillips head screws from the holes in the column
• Tilt the steering column down
• Pop out the panel and remove it from the column
• Unscrew the steering lever
• Remove the bottom cover
• Remove the upper cover

step : Removing the Shift Lever (1:58)

• Push down on the metal tab near the ignition cylinder to release the lever boot
• Pop open the clamshell securing the wire harness with a pick and remove it
• Tap out the retaining pin with a hammer and punch
• Remove the shift lever
• Remove the harness from its retainers
• Disconnect the harness from the bottom of the steering column

step : Installing the Shift Lever (4:29)

• Send the connector down into the column and run it into place
• Connect the connector
• Reinstall the shift lever into the column
• Reinstall the retaining pin
• Snap the boot into place

step : Installing the Steering Column Cover (6:05)

• Reinstall the two halves of the steering column cover
• Tighten the three Phillips head screws to the cover
• Reinstall the ignition cylinder
• Turn it back and remove the key
• Screw in the tilt column switch
• Reinstall the rear cover