2003-07 Mirror - 1AMRE01312

Specifications:

• Fits Driver side
• Power mirror
• Heated mirror
• Injection molded black plastic housing
• Direct replacement
• Built to strict quality control standards

Special Note:

• Unless otherwise noted, replacement mirrors will only work properly on vehicles with the exact same options. If your vehicle does not have the options listed in specifications, the mirror(s) may not function properly.

Item Condition: New

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Removing power windows requires removing the door panel. Removing manual windows does not.

step : Removing the Door Panel (2:24)

• Remove the door panel if you have power mirrors
• If you have manual mirrors, proceed to Step 2
• Pry off the door pull trim piece with a flat blade screwdriver
• Remove the six Phillips head screws inside the door pull
• Pry off the door panel bezel with a flat blade screwdriver
• Remove the two Phillips head screws inside the door handle
• Pry off the switch panel by hand
• Disconnect the door lock wiring harness
• Disconnect the window switch wiring harnesses
• Disconnect the mirror switch wiring harness
• Pry off the mirror base trim piece by hand
• Pry out the door panel by hand
• Lift the door panel up and off

step : Removing the Mirror (1:03)

• Pull off the mirror base trim piece if you have not already done so
• Remove the three 10mm nuts from the mirror
• Pull the mirror off

step : Installing the Mirror (1:48)

• Put the mirror into place
• Fasten the three 10mm nuts onto the mirror
• Continue to Step 4 if you have removed the door panel
• Otherwise, push on the mirror base trim piece

step : Reinstalling the Door Panel (4:15)

• Lift the door panel into place
• Push in the door panel clips
• Connect the door lock wiring harness
• Connect the mirror switch wiring harness
• Connect the window switch wiring harnesses
• Push the switch panel into place
• Insert the two Phillips head screws inside the door handle
• Push on the door handle bezel
• Push on the mirror base trim piece
• Insert the six Phillips head screws inside the door pull
• Push on the door pull trim piece