Replaces

1997-2005 Buick Century Power Window Regulator with Motor Rear Passenger Side (High Quality)

Part Details

  • Part Type: High Quality
  • Window Options: with Motor
  • Operation: Power
  • Front / Rear Location: Rear
  • Side Location: Passenger Side

This part replaces:

  • HOLLANDER 135-01776R, 135-01857R
  • PARTSLINK GM1551101
  • OE # 10334398, 88987652
  • DORMAN 741-709

  • New

This replacement power window regulator and motor is just what you need to get your vehicle in good shape again!

Specifications:

  • Fits RH (Passenger Side) REAR
  • Power operation
  • Replaces dealer part numbers: 10334398, 88987652
  • Includes the power window motor
  • Direct replacement
  • Built to strict quality control standards
  • Motor and regulator pre-assembled for easier installation

This window regulator and motor makes a great replacement and has good cost savings over a dealer unit.

Please Note: This High Quality power window regulator is a new aftermarket replacement part that is built to strict quality control standards. It is far superior to the lower quality window regulators which have begun to appear on the internet. Although this window regulator is produced overseas, it was designed in the U.S. and the tooling is owned by a large U.S. manufacturer. That is why we guarantee this high quality window regulator with a superior warranty! If price is your main concern, we do offer the lower price overseas designed and built window regulator in our other listings.

Installation

  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money, and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle, if this Window regulator does not fit the application stated.
    • You can use your existing hardware and wiring harnesses. This Regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.
  • Nothing is more frustrating than taking your car apart and finding the part you purchased does not fit. You want the part to fit. This design is test fit on an actual door. When you install it, you will have no issues.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

 

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Door (0:57 in the video)
    • Pull up on the window switch trim
    • Disconnect the window switch wiring harnesses with a flat blade screwdriver
    • Pry off the trim piece inside the door handle with a flat blade screwdriver
    • Remove the Phillips head screw inside the door handle
    • Remove the two T30 Torx screws inside the door handle
    • Remove the door handle bezel
    • Pry out the door panel with a door panel clip tool or putty knife
    • Pry off the base trim piece by hand
    • Lift the door panel up and off
    • Carefully peel off the water shield
  2. Removing the Window Regulator (4:15 in the video)
    • Lower the window by hand
    • Remove the two 10mm bolts that hold the window to the regulator
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Disconnect the window motor wiring lead
    • Remove the three 10mm bolts from the window motor
    • Disconnect the window motor lead
    • Remove the two 10mm bolts from the regulator and loosen the other two
    • Pull the window regulator out through the door
  3. Installing the New Window Regulator (6:15 in the video)
    • Transfer the three motor bolts to the new motor and the two in the old regulator
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Insert the four 10mm bolts into the regulator
    • Insert the three 10mm bolts from the window motor
    • Remove the painter's tape from the window
    • Lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
    • Reconnect the window motor lead
    • Reconnect the window harness
    • Turn the car on
    • Disconnect the window harness
  4. Reinstalling the Door Handle (9:10 in the video)
    • Put the water shield into place
    • Lift the door panel into place
    • Push in the door panel clips
    • Re-clip the door handle bezel
    • Insert the two T30 Torx screws inside the door handle
    • Insert the Phillips head screw inside the door handle
    • Insert the trim piece inside the door handle
    • Connect the window switch wiring harnesses
    • Clip the window switch panel

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • Painter's Tape

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Putty Knife

  • Torx Drivers & Sockets

  • T30 Torx Driver

  • Wrenches - Metric

  • 10mm Wrench

How-to Video:

(10:13 min)

Tools List:

    Materials, Fluids, and Supplies

  • Painter's Tape

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Putty Knife

  • Torx Drivers & Sockets

  • T30 Torx Driver

  • Wrenches - Metric

  • 10mm Wrench



This part replaces:

  • HOLLANDER 135-01776R, 135-01857R
  • PARTSLINK GM1551101
  • OE # 10334398, 88987652
  • DORMAN 741-709

Vehicle Fit

  • 1997-2005 Buick Century Power Window Regulator with Motor Rear Passenger Side (High Quality)
  • 1997-2004 Buick Regal Power Window Regulator with Motor Rear Passenger Side (High Quality)
  • 1998-2002 Olds Intrigue Power Window Regulator with Motor Rear Passenger Side (High Quality)
$56.90
Save 83%
List: $336.38 Save: $279.48
Part #: 1AWRG00269

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est