Replaces

2002-2004 Infiniti I35 Power Window Regulator with Motor with 6 Terminal Connection Front Driver Side

Part Details

  • Operation: Power
  • Location: Front
  • Location: Driver Side

This part replaces:

  • HOLLANDER 125-58768L, 617-58492L
  • PARTSLINK NI1350111
  • OE # 80721-2Y000, 80731-2Y90

  • New

This window regulator is a high quality replacement. The benefit of our regulator is our manufacturer. They studied the faults of the original equipment manufacturer, then made changes and re-engineered to correct those faults.

Specifications:

  • Fits LH (Driver Side) FRONT
  • Power operation
  • Replaces dealer part numbers: 80721-2Y000, 80731-2Y900, 807212Y000, 807312Y900
  • Includes the Power Window Motor
  • Motor has a 6 Pin Connector
  • Direct replacement
  • Built to strict quality control standards

Window Regulator Installation Tips and FAQ.

This part makes a great replacement and has substantial cost savings over a dealer unit.

Installation

  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money, and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle, if this Window regulator does not fit the application stated.
    • You can use your existing hardware and wiring harnesses. This Regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.
  • Nothing is more frustrating than taking your car apart and finding the part you purchased does not fit. You want the part to fit. This design is test fit on an actual door. When you install it, you will have no issues.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

 

2 Year Warranty

This item is backed by a 2 Year Warranty. In the event this item should fail during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Removing the Door Panel (0:46 in the video)
    • Pop off the cover at the front top corner of the door panel with a flat blade screwdriver
    • Pry off the trim piece inside the door pull with a flat blade screwdriver
    • Pry off the door handle bezel with a flat blade screwdriver
    • Remove the Phillips head screw at the front top corner of the door panel
    • Remove the Phillips head screw inside the door pull
    • Pull the switch panel up by hand
    • Disconnect the door lock wiring harness
    • Disconnect the window switch wiring harnesses
    • Pry out the door panel with a door panel clip tool or putty knife
    • Lift the door panel up and off
    • Disconnect the door module wiring harness
    • Disconnect the courtesy light wiring harness
    • Disconnect the memory seat wiring harness
    • Remove the two bolts from the regulator bracket
    • Carefully remove the water shield
  2. Removing the Window Regulator (4:21 in the video)
    • Disconnect the window motor lead
    • Remove the two 10mm bolts that hold the window to the regulator
    • Raise the window by hand
    • Tilt the window forward and remove it
    • Loosen one and remove three 10mm bolts from the regulator
    • Remove the three 10mm bolts from the window motor
    • Pull the window regulator out through the door
  3. Installing the New Window Regulator (6:56 in the video)
    • Transfer the 10mm bolt from the old regulator to the new one
    • Insert one of the bolts into the window regulator
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Insert and tighten the three 10mm bolts into the regulator
    • Insert and tighten the three 10mm bolts from the window motor
    • Connect the window motor to the lead
    • Lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
  4. Testing the Motor (10:35 in the video)
    • Connect the window switch wiring harness
    • Turn the vehicle on
    • Run the motor up for 4 seconds
    • Disconnect the window switch wiring harness
  5. Reinstalling the Door Panel (11:01 in the video)
    • Put the water shield into place
    • Insert and tighten the two 10mm bolts into the regulator bracket
    • Connect the door module wiring harness
    • Connect the courtesy light wiring harness
    • Connect the memory seat wiring harness
    • Lift the door panel into place
    • Push in the door panel clips
    • Insert the Phillips screw at the top front corner of the door panel
    • Connect the door lock wiring harness
    • Connect the window switch wiring harnesses
    • Clip in the switch panel
    • Replace the door handle bezel
    • Insert the Phillips head screw inside the door pull
    • Insert the cover at the front top corner of the door panel with a flat blade screwdriver

Tools needed for replacement:

    Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Putty Knife

How-to Video:

(12:58 min)

Tools List:

    Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Putty Knife



This part replaces:

  • HOLLANDER 125-58768L, 617-58492L
  • PARTSLINK NI1350111
  • OE # 80721-2Y000, 80731-2Y90

Vehicle Fit

  • 2000-2001 Infiniti I30 Power Window Regulator with Motor with 6 Terminal Connection Front Driver Side
  • 2002-2004 Infiniti I35 Power Window Regulator with Motor with 6 Terminal Connection Front Driver Side
  • 2000-2003 Nissan Maxima Power Window Regulator with Motor with 6 Terminal Connection Front Driver Side
$65.45
Save 81%
List: $352.04 Save: $286.59
Part #: 1AWRG00322

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est