Replaces

2001-2007 Toyota Sequoia Power Window Regulator (without Motor) Front Door Driver Side

Part Details

  • Operation: Power
  • Front / Rear Location: Front
  • Side Location: Driver Side

This part replaces:

  • OE # 698020C020
  • DORMAN 749-240
  • HOLLANDER 125-58888L

  • New

This window regulator is just what you need to get your vehicle in good working form again!

Specifications:

  • Fits LH (Driver Side) FRONT
  • Power operation
  • Replaces dealer part numbers: 69802-0C010, 69802-0C020, 698020C010, 698020C020
  • Direct replacement
  • Built to strict quality control standards
  • Does NOT include the power window motor
This window regulator is a great replacement that offers good cost savings over the dealer part!

Please Note: This High Quality power window regulator is a new aftermarket replacement part that is built to strict quality control standards. It is far superior to the lower quality window regulators which have begun to appear on the internet. Although this window regulator is produced overseas, it was designed in the U.S. and the tooling is owned by a large U.S. manufacturer. That is why we guarantee this high quality window regulator with a superior warranty! If price is your main concern, we do offer the lower price overseas designed and built window regulator in our other listings.

Installation

  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money, and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle, if this Window regulator does not fit the application stated.
    • You can use your existing hardware and wiring harnesses. This Regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.
  • Nothing is more frustrating than taking your car apart and finding the part you purchased does not fit. You want the part to fit. This design is test fit on an actual door. When you install it, you will have no issues.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

 

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. Disconnecting the Battery (0:41 in the video)
    • Disconnect the negative battery cable with a 10mm wrench
  2. Removing the Door Panel (0:54 in the video)
    • Pry off the mirror base trim piece with a flat blade screwdriver
    • Pry up the window switch panel with a flat blade screwdriver
    • Disconnect the window switch wiring harness
    • Pry off the trim piece beneath the door pull with a flat blade screwdriver
    • Pry off the courtesy light with a flat blade screwdriver
    • Disconnect the courtesy light wiring harness
    • Pry off the trim piece inside the door handle with a flat blade screwdriver
    • Pry off the trim piece at the front top corner of the door panel with a flat blade screwdriver
    • Remove the Phillips head screw at the front top corner of the door panel
    • Remove the Phillips head screw inside the door handle
    • Remove the Phillips head screw beneath the door pull
    • Pry off the door handle bezel with a flat blade screwdriver
    • Pry the two plastic pins out of the rear edge of the door panel with a flat blade screwdriver
    • Pry out the door panel with a door panel clip tool or putty knife
    • Lift the door panel up and off
    • If any pins remain in the door panel remove them with pliers
    • Push the pins into the door panel
    • Carefully peel back the water shield
    • Remove the three 10mm bolts from the speaker
    • Disconnect the speaker wiring lead Pull off the speaker
  3. Removing the Window Regulator (4:29 in the video)
    • Disconnect the window motor lead
    • Unclip the window motor wiring from the door
    • Remove the two 10mm bolts from the window track
    • Remove the four 10mm bolts from the regulator
    • Lower the window by hand
    • Remove the two 10mm bolts that hold the window to the regulator
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Pull the window regulator out through the door
  4. Reinstalling the Regulator (7:10 in the video)
    • Insert one of the bolts into the window regulator
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Insert the four 10mm bolts into the regulator
    • Insert the two 10mm bolts into the window track
    • Remove the painter's tape from the window
    • Connect the window motor lead
    • Connect the negative battery cable with a 10mm wrench
    • Connect the window switch wiring harness
    • Lower the regulator with the switch
    • Lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
    • Test the regulator with the switch
    • Disconnect the window switch wiring harness
  5. Reinstalling the Door Panel (9:41 in the video)
    • Put the water shield into place
    • Put the speaker into place
    • Connect the speaker wiring lead
    • Insert the three 10mm bolts into the speaker
    • Lift the door panel into place
    • Push in the door panel clips
    • Push on the mirror base trim piece
    • Push on the door handle bezel
    • Connect the window switch wiring harnesses
    • Push in the window switch panel
    • Connect the courtesy light wiring harness
    • Push on the wiring harness
    • Insert the Phillips screw beneath the door pull
    • Insert the Phillips screw into the door handle
    • Insert the Phillips screw at the top front corner of the door panel
    • Push on the trim piece at the top front corner of the door panel
    • Push on the trim piece inside the door handle
    • Push on the trim piece beneath the door pull
    • Push the two plastic clips into the rear of the door panel
  6. Reconnecting the Battery (11:59 in the video)
    • Connect the negative battery cable with a 10mm wrench, if you have not already done so

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • Painter's Tape

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Door Panel Removal Tool
  • Putty Knife

  • Wrenches - Metric

  • 10mm Wrench

How-to Video:

(12:24 min)

Tools List:

    Materials, Fluids, and Supplies

  • Painter's Tape

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Door Panel Removal Tool
  • Putty Knife

  • Wrenches - Metric

  • 10mm Wrench



This part replaces:

  • OE # 698020C020
  • DORMAN 749-240
  • HOLLANDER 125-58888L

Vehicle Fit

  • 2001-2007 Toyota Sequoia Power Window Regulator (without Motor) Front Door Driver Side
  • 2004-2006 Toyota Tundra Double Cab Power Window Regulator (without Motor) Front Door Driver Side
$26.95
Save 82%
List: $148.03 Save: $121.08
Part #: 1AWRG01970

- Ships Same Day for orders placed by 5 P.M. ET

Free GROUND SHIPPING

Check Shipping Rates

We're here to help

Customer Feedback

Customer Feedback
"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More
Free Shipping!
OR
CALL
TOLL
FREE

888-844-3393

hablamos Español:866-401-3393
SHIPS SAME DAY
For Orders Placed By 5pm Est