VW Jetta Driver Side Tail Light DEPO

This replacement Tail light is just what you need to get your vehicle in good looking form again!

This tail lamp features the following specifications:

• LH (Driver Side)
• Replaces dealer part numbers: 1JM 945 111, 1JM945111
• Includes lens & Housing
• DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
• Direct replacement
• Correct for Sedan Models

Note: This tail light will fit as an upgrade for 99-03 models but are cosmetically different.

This tail light makes a great replacement and has good cost savings over a dealer unit.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

Direct fit replacement for OEM assembly

Uses same wiring as original assembly.  No cutting or splicing required.

Meets federal regulations for on-road use

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

step : Removing the Tail Light (0:33)

• Remove the panel inside the trunk
• Loosen the three 8mm nuts from the tail light bracket
• Remove the three 8mm nuts from the tail light bracket by hand
• Pull the tail light out
• Disconnect the tail light wiring harness with a flat blade screwdriver

step : Servicing the Bulbs (1:16)

• Push the tabs on either side of the bulb panel and remove it
• Twist the bulb socket counterclockwise out of the light
• Pull the bulb off of the socket
• Push on the new bulb
• Twist the bulb clockwise into the light

step : Installing the New Tail Light (1:36)

• Push the panel into the tail light
• Reconnect the wiring harness to the tail light
• Line up the bolt holes on the tail light bracket to the bolt holes on the vehicle
• Replace two 8mm nuts into the tail light bracket
• Replace the panel inside the trunk