Replaces

Volkswagen Beetle Golf Jetta Steering & Suspension Kit - 1ASFK03288

Specifications:

  • Brand New Steering & Suspension Kit
  • Comes as a Set of 10
  • Direct replacements
  • built to strict quality control standards

Our steering and suspension components are sealed for long life and do not require the extra maintenance typically required by greasable versions.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Direct Fit

All parts are direct fit, application-specific parts with no modifications required

Rigorously Tested

Rigorously tested and made from higher quality materials than the competition. Our parts are built to have a longer life in any environment or road conditions.

State of the Art Manufacturing

Our parts are manufactured by some of the same factories that the OEMs use.

Prepackaged for Your Convenience

Our kits have been carefully put together to include all of the parts you need to get the job done, saving you both time and money. These kits also help take the guesswork out of finding the correct part for your vehicle’s steering or suspension system, allowing you to get started on your repair project faster.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Wheel (0:55)
    • Remove the lug nut caps with a 7mm Allen bit
    • Insert the lug nut key into the locking lug nut
    • Loosen the lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Outer Tie Rod (1:47)
    • Measure the distance from the inner tie rod boot to the end of the outer tie rod
    • Record that measurement
    • Loosen the 22mm nut that attaches the inner tie rod to the outer tie rod
    • Use a 6mm Allen wrench and a 19mm wrench to remove the nut at the bottom of the tie rod end
    • Loosen the tie rod by striking the steering knuckle with a hammer
    • Pull the tie rod up and out of the steering knuckle
    • Twist off the outer tie rod
  3. step : Installing the New Outer Tie Rod (2:48)
    • Twist the new outer tie rod onto the inner tie rod
    • Push the outer tie rod into the steering knuckle
    • Fasten the nut onto the outer tie rod with a 19mm wrench and a 6mm Allen wrench
    • Tighten the 19mm nut to 50 foot-pounds of torque
    • Measure the distance from the inner tie rod boot to the end of the outer tie rod
    • Check that this is the same distance as recorded in Step 2
    • Tighten the 22mm nut that attaches the inner tie rod to the outer tie rod
  4. step : Reattaching the Wheel (3:43)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 100 foot-pounds in a crossing or star pattern
    • Attach the lug nut covers

Tools needed for replacement:

    Allen Wrenches

  • 6mm Allen Wrench
  • 7mm Allen Wrench

  • General Tools

  • Measuring Tape
  • Hammer
  • Floor Jack
  • Jack Stands

  • Ratchets & Related

  • Ratchet
  • Torque Wrench

  • Sockets - Metric

  • 19mm Socket
  • 17mm Socket

5.0 / 5.0
2 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
2
0
0
0
0
Good deal - better ride
Everything needed to take the slop out of the front end and improve handling. Not terribly hard to replace it all. Removing the first ball joint was a pain but other side of the car was a breeze once I knew what to expect. Just don't forget to do an alignment when you'return done. My toe moved more than 3/8" with the new parts installed.
March 6, 2017
Purchased
1 year ago
Awesome!
This pack included everything I needed and for a fraction of the cost!
April 26, 2018
Purchased
3 weeks ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2001-2010 VW Beetle Steering & Suspension Kit 10 Piece Set for Models with Sport Suspension
  • 2001-2005 VW Golf Steering & Suspension Kit 10 Piece Set for Models with Sport Suspension (excluding R32 Models)
  • 2006 VW Golf Steering & Suspension Kit 10 Piece Set for Models with Sport Suspension (8th Vin Digit J)
  • 2000-2004 VW Jetta Steering & Suspension Kit 10 Piece Set for Models with Sport Suspension
  • 2005 VW Jetta Steering & Suspension Kit 10 Piece Set for Models with Sport Suspension (8th Vin Digit J or M)

This part replaces:

  • Dorman 520-760
  • Hollander 512-58513AL, 512-58513AR
  • OE # 1J0 407 151 C, 1J0 407 151B
  • OE # 1J0422812B
  • OE # 1J0411315K
  • OE # 1J0422811B
  • OE # 1J0407365H, 1J0407365C
  • OE # 1J0407366H
  • OE # 1J0422804
  • Moog K90355
  • Moog K90357
  • Moog K90715
  • Moog EV400
  • Moog ES3525
  • Moog ES3524
  • Moog K640176
  • Beck Arnley 102-5884
  • Dorman N/A
Part #: 1ASFK03288


How-to Video:

(04:33 min)