1AWPM00232-Toyota Sequoia Tundra Front Driver Side Power Window Motor

Replaces

Toyota Sequoia Tundra Front Driver Side Power Window Motor Dorman 742-615

1AWPM00232

This part replaces:

  • Dorman 742-615
  • Hollander 617-58605L
  • OE # 8572034030
FREE SHIPPING
BUY NOW!
SHIPS DIRECT
Part 1AWPM00232
Ships in 1-3 Business Days

Dorman
Brand #: 742-615

Frequently bought together

Description
Vehicle Fit
Warranty & Shipping
How-To & Tools

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

Returns: Parts with electrical components cannot be returned once installed.

48 States Only: Due to shipping restrictions, we can only ship this to a street address within the Contiguous U.S. (lower 48 states).

  1. step : Disconnecting the Battery (0:50)
    • Disconnect the negative battery cable
  2. step : Removing the Door Panel (1:01)
    • Pry off the mirror base trim with a flat blade screwdriver
    • Pry off the window switch panel with a flat blade screwdriver
    • Disconnect the window switch wiring harnesses
    • Pry off the screw cover beneath the door pull with a flat blade screwdriver
    • Pry off the courtesy light with a flat blade screwdriver
    • Disconnect the courtesy light wiring harness
    • Pry off the screw cover inside the door panel with a flat blade screwdriver
    • Pry off the screw cover at the front top corner of the door panel with a flat blade screwdriver
    • Remove the Phillips head screw at the front top corner of the door panel
    • Remove the Phillips screw inside the door handle
    • Remove the Phillips screw under the door pull
    • Pry off the door handle bezel with a flat blade screwdriver
    • Remove the two plastic clips from the back edge of the door panel
    • Pry off the door panel with a door panel clip tool or a putty knife
    • Pull the door panel up and off
    • Remove any clips still in the door with needle nose pliers
    • Push the clips into the door panel
    • Carefully peel back the water shield
    • Remove three bolts from the speaker
    • Remove the speaker
  3. step : Removing the Window Regulator (4:34)
    • Disconnect the window motor wiring harness
    • Remove the two 10mm bolts from the window track
    • Remove the four 10mm bolts from the window regulator
    • Remove the two 10mm bolts from the window clamps
    • Separate the window from the regulator
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Pull the regulator out of the door
  4. step : Separating the Window Motor (7:18)
    • Pry off the balance spring with a flat blade screwdriver
    • Remove the three T25 Torx screws from the motor
    • Separate the motor from the regulator
  5. step : Installing the New Window Motor (8:11)
    • Put the motor into place
    • Start the three T25 Torx screws
    • Tighten the screws
    • Pull the spring into place with a flat blade screwdriver
  6. step : Reinstalling the Regulator (9:02)
    • Thread the top bolt onto the regulator
    • Slide the regulator into the door.
    • Hang the regulator by its bolt
    • Start the other five 10mm bolts into the regulator
    • Tighten the six 10mm bols
    • Reconnect the window motor lead
    • Reconnect the negative battery cable
    • Reconnect the window switch wiring harness
    • Turn on the vehicle
    • Lower the regulator with the window switch
    • Remove the painter's tape from the window
    • Slide the window down onto the regulator
    • Insert the two 10mm bolts into the window clamps
    • Test that the window works with the window switch
    • Turn off the vehicle
    • Disconnect the window switch harness
    • Disconnect the negative battery cable
  7. step : Reinstalling the Door Panel (11:33)
    • Put the water shield back into place
    • Put the speaker into place
    • Insert the three bolts into the speaker
    • Lift the door panel into place
    • Pull the wiring harnesses through their cavities
    • Push on the mirror trim piece
    • Push on the door panel bezel
    • Connect the window switch wiring harness
    • Push in the window switch panel
    • Connect the courtesy light wiring harness
    • Insert the Phillips screw below the door pull
    • Insert the Phillips screw inside the door handle
    • Insert the Phillips screw at the top front corner of the door panel
    • Push in the screw cover at the top front corner of the door panel
    • Push in the screw cover inside the door handle
    • Push in the screw cover beneath the door pull
    • Push in the two plastic clips at the rear edge of the door panel
  8. step : Reconnecting the Battery (13:53)
    • Reconnect the negative battery cable

Tools needed for replacement:

    General Tools

  • Putty Knife

  • Materials, Fluids, and Supplies

  • Painter's Tape

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Door Panel Removal Tool


Fits the following Makes:

Year Make Model Description
2001-2007Toyota Sequoia Toyota Sequoia Front Driver Side Power Window Motor
2004-2006Toyota Tundra Toyota Tundra Crew Cab Front Driver Side Power Window Motor
FREE SHIPPING
Dorman
Brand #: 742-615
Product Reviews
3.00/ 5.0 1
1review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
0
0
1
0
0
Works but loud
April 1, 2019
This is not a simple bolt in replacement. It requires you to tap the holes to the screw size of your vehicle. Mine was a M5 which took a bit to find as an individual dye. Was happy the window worked after installed but was considerably louder. I thought it would quiet down once it was fully installed and the door panel installed but it did not..
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Customer service

877-844-3393

Monday - Friday 8:00am - 9:30pm ET
Saturday - Sunday 8:00am - 4:30pm ET


Toyota Sequoia Tundra Front Driver Side Power Window Motor Dorman 742-615-1AWPM00232 does not fit your:



Same Day Shipping

Orders ship same day when ordered by 2pm ET. Need your part faster? Choose expedited shipping at checkout.

Guaranteed To Fit

Providing you the highest quality, direct fit replacement auto parts enforced to the strictest product standards.

USA Customer Support

Exceeding customers' expectations every day, our team of passionate auto enthusiasts are here to help.

Instructional Video Library

Thousands of how-to auto repair videos specific to year, make and model guide you step-by-step through your repair.

Before proceeding,

select your Vehicle, to verify this Part will fit.

This part will only fit a vehicle with these options.