Steering Kit 3 Piece Set TRQ PSA58581

Specifications:

• Brand New Steering Rack & Tie Rod Kit
• New Power Rack & Pinion Assembly
  • not remanufactured, no core charge
• Rack includes gear assembly, inner tie rods, & rack boots
• Direct replacements
• Built to strict quality control standards

Our steering and suspension components come pre-greased, sealed for long life, and do not require the extra maintenance typically required by greasable versions.

Application-specific, with no modifications required.

Made from higher quality materials than the competition. Built to have a longer life in any environment or road conditions.

By the same factories that the OEMs use.

Carefully assembled to include all of the parts you need, saving time and money.

Item Condition: New

Attention California Customers:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

Note: When replacing steering components, it is recommended to have a professional alignment performed on the vehicle afterwards. This will ensure proper tracking and even tire wear.

step : Removing the Wheel (0:43)

• Pry off the hub cap with a flat blade screwdriver
• Loosen the 35mm hub nut with the vehicle on the ground
• Loosen the lug nuts
• Raise the vehicle with a floor jack
• Secure the vehicle on jack stands
• Remove the lug nuts
• Pull off the wheel

step : Removing the Outer Tie Rod (1:08)

• Spray both ends of the outer tie rod with penetrating oil
• Measure from the either end of the outer tie rod
• Place a 26mm wrench on the larger nut
• Place a 22mm wrench on the smaller nut
• Break the 22mm nut free
• Straighten the cotter pin with pliers and pull it through
• Remove the nut with a 21mm socket from the wheel knuckle
• Hit the wheel knuckle with a hammer
• Twist off the outer tie rod
• Remove the 22mm nut off the outer tie rod

step : Installing the New Outer Tie Rod (3:08)

• Mark where the 22mm nut was located on the old tie rod to the new tie rod
• Screw on the nut
• Twist the outer tie rod into place
• Push the outer tie rod into the wheel knuckle
• Measure and check the outer tie rod distance
• Tighten the 21mm nut on the wheel knuckle
• Insert and twist the cotter pin with a pair of pliers
• Tighten the two nuts on the outer tie rod

step : Reattaching the Wheel (4:33)

• Slide the wheel into place
• Start the lug nuts by hand
• Tighten the lug nuts preliminarily
• Lower the vehicle to the ground
• Tighten the hub nut
• Torque the lug nuts to 100 ft/lbs in a crossing or star pattern
• Torque the hub nut to 103 ft/lbs
• Reattach the center cap