Specifications:

  • Brand New Suspension & Steering Kit
  • Comes as a Set of 12
  • Fits LH (Driver Side) & RH (Passenger Side) Front
  • Direct replacements
  • Built to strict quality control standards

Our steering and suspension components are sealed for long life and do not require the extra maintenance typically required by greasable versions.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Direct Fit

All parts are direct fit, application-specific parts with no modifications required

Rigorously Tested

Rigorously tested and made from higher quality materials than the competition. Our parts are built to have a longer life in any environment or road conditions.

State of the Art Manufacturing

Our parts are manufactured by some of the same factories that the OEMs use.

Prepackaged for Your Convenience

Our kits have been carefully put together to include all of the parts you need to get the job done, saving you both time and money. These kits also help take the guesswork out of finding the correct part for your vehicle’s steering or suspension system, allowing you to get started on your repair project faster.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Wheel (0:46)
    • Remove the center cap with a cap removal tool or pick
    • Loosen the 17mm lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Outer Tie Rod (1:42)
    • Loosen the 22mm nut 1/4 a turn while holding the 18mm nut behind it
    • Remove the 13mm nut on top of the tie rod end
    • Remove the 16mm nut on the side of the tie rod end
    • Hand tighten the 16mm bolt and drive the bolt out
    • Pry the tie rod out of the knuckle
    • Hold the 18mm nut from the outer tie rod end
    • Twist off the outer tie rod by hand
  3. step : Installing the Outer Tie Rod (4:00)
    • Set the lock nut to the same position as the original
    • Thread the outer tie rod in while holding the 18mm nut
    • Twist the tie rod with a pair of pliers to insert it into place
    • Hammer the tie rod into the steering knuckle
    • Tighten the 13mm bolt to the grease fitting
    • Tighten the 16mm bolt to the grease fitting
    • Hold the 18mm nut and tighten the 22mm locking nut
  4. step : Reattaching the Wheel (6:33)
    • Slide the wheel into place
    • Start the 17mm lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 90 foot-pounds in a star pattern
    • Reattach the center cap

Tools needed for replacement:

    General Tools

  • Jack Stands
  • Hammer
  • Pick
  • Floor Jack

  • Materials, Fluids, and Supplies

  • Rust Penetrant

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Sockets - Metric

  • 16mm Socket
  • 17mm Socket
  • 13mm Socket

  • Specialty Tools

  • Audi Wheel Cap Removal Tool

  • Wrenches - Metric

  • 22mm Wrench
  • 18mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1997-2001 Audi A4 Sedan 12 Piece Set Steering & Suspension Kit
  • 1997-2001 Audi A4 Quattro Sedan 12 Piece Set Steering & Suspension Kit
  • 1998-2004 Audi A6 12 Piece Set Steering & Suspension Kit Front Wheel Drive
  • 2000-2001 Audi S4 12 Piece Set Steering & Suspension Kit
  • 2002 Audi S4 12 Piece Set Steering & Suspension Kit (8th Vin Digit D)
  • 1998-2002 VW Passat 12 Piece Set Steering & Suspension Kit
  • 2003 VW Passat 12 Piece Set Steering & Suspension Kit Front Wheel Drive (Built Before VIN 3B3072000)

This part replaces:

  • Dorman 520-763
  • Dorman 520-764
  • Dorman 520-765
  • Dorman 520-766
  • Dorman 520-767
  • Dorman 520-768
  • Hollander 511-58167L
  • Hollander 511-58166R
  • Hollander 511-58126L
  • Hollander 511-58126R
  • Hollander 512-58643L, 512-58912L
  • Hollander 512-58644R, 512-58913R
  • OE # 8E0407505A
  • OE # 8E0407506A
  • OE # 8D0407509A, 8D0407509F, 8D0407509C, 8D0407509E, 8D0407509P
  • OE # 8D0407510A, 8D0407510F, 8D0407510C, 8D0407510E, 8D0407510P
  • OE # 4B0419811E, 4F0419811D
  • OE # 8E0407693AG, 4D0407693AC
  • OE # 8E0407694AG, 4D0407694AC
  • Moog K80562
  • Moog K80563
  • Moog K90497
  • Moog K90498
  • Moog K90494
  • Moog EV440
  • Moog K80525
  • Moog K80526
  • Moog ES3646
  • Dorman 520-762
  • Hollander 512-58428
Part #: 1ASFK02643

Out of Stock

How-to Video:

(07:49 min)