Specifications:

  • Brand New Steering & Suspension Kit
  • Comes as a 10 Piece Kit
    • Fits LH (Driver Side) & RH (Passenger Side)
  • Direct replacements
  • Built to strict quality control standards

Our steering and suspension components come pre-greased, sealed for long life, and do not require the extra maintenance typically required by greasable versions.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Direct Fit

All parts are direct fit, application-specific parts with no modifications required

Rigorously Tested

Rigorously tested and made from higher quality materials than the competition. Our parts are built to have a longer life in any environment or road conditions.

State of the Art Manufacturing

Our parts are manufactured by some of the same factories that the OEMs use.

Prepackaged for Your Convenience

Our kits have been carefully put together to include all of the parts you need to get the job done, saving you both time and money. These kits also help take the guesswork out of finding the correct part for your vehicle’s steering or suspension system, allowing you to get started on your repair project faster.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Remove the wheel (1:14)
    • Loosen the lug nuts with your lug wrench.
    • Raise and secure the car.
    • Remove the lug nuts and remove the wheel.
  2. step : Remove the stabilizer link (1:35)
    • Spray the bolts with penetrating oil
    • Use a 5mm Allen wrench and an 18 mm wrench to remove the nut and bolt on the stabilizer link.
    • Repeat on the bottom.
    • Use a Sawzall to remove the stabilizer link if it is rusted on there.
    • You can rent a Sawzall at a home improvement supply store.
  3. step : install the new stabilizer links (6:20)
    • Put the stabilizer link in place and use your wrench to bolt the locking lug nuts on.
  4. step : Put the wheel back on (7:38)
    • Hand-tighten the lug nuts and then lower the car.
    • Refer to the owner’s manual to torque the lug nuts to the correct ft lbs.
    • Use a star pattern.

Tools needed for replacement:

    Allen Wrenches

  • 5/16 Inch Allen Wrench

  • Materials, Fluids, and Supplies

  • Rust Penetrant

  • Pliers, Cutters & misc Wrenches

  • Lug Wrench

  • Wrenches - SAE

  • 3/4 Inch Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 3 answers
Is it safe to drive without sway bars?
Is it safe to drive without a front stabilizer bar?
Barbara G on Feb 5, 2016
BEST ANSWER: Hello, I will say no to this question. This is a state inspection item in most states. The purpose is to stabilize the vehicle to prevent excessive body lean or sway. These parts are important and even more critical in the case of evasive driving i.e. avoiding a collision by hard steering.

Vehicle Fit

  • 2000 Chrysler Grand Voyager 10 Piece Set Steering & Suspension Kit
  • 1996-2000 Chrysler Town & Country 10 Piece Set Steering & Suspension Kit
  • 2000 Chrysler Voyager 10 Piece Set Steering & Suspension Kit
  • 1996-2000 Dodge Caravan 10 Piece Set Steering & Suspension Kit
  • 1996-2000 Dodge Grand Caravan 10 Piece Set Steering & Suspension Kit
  • 1996-2000 Plymouth Grand Voyager 10 Piece Set Steering & Suspension Kit
  • 1996-2000 Plymouth Voyager 10 Piece Set Steering & Suspension Kit

This part replaces:

  • Moog K7301
  • Moog EV362
  • Moog K7258
  • Moog ES3401RL
  • Dorman 520-343
  • Dorman 520-344
  • Hollander 512-01128L
  • Hollander 512-01128R
  • OE # 4694761AC
  • OE # 5272190
  • OE # 4694760AC
Part #: 1ASFK01098


How-to Video:

(07:55 min)