Spare Tire Carrier & Hoist Assembly Dorman 924-511 - 1ASTW00003

Specifications:

• Brand New Spare Tire Carrier & Hoist Assembly
• Direct replacement
• Built to strict quality control standards

Item Condition: New

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Lowering the Spare Tire (0:53)

• Open the storage compartment
• Open the spare tire hoist cap
• Turn the hoist with the tire iron
• If the mechanism is frozen, support the spare tire with a jack
• Cut the tire support with a torch or reciprocating saw
• Lower the wheel to the ground
• If the mechanism is working, lower the tire to the ground with the hoist
• Remove the tire from the support

step : Removing the Spare Tire Hoist (2:50)

• Remove the four 13mm bolts from the tire hoist
• Remove the hoist from the frame

step : Installing the Spare Tire Hoist (3:58)

• Lift the hoist into place
• Line up the hoist using the pins
• Start the four 13mm bolts into the hoist
• Tighten the four 13mm bolts to 25 to 30 foot-pounds of torque

step : Raising the Spare Tire (4:36)

• Turn the hoist with a tire iron to let out the cable
• Insert the tire support through the center of the tire
• Raise the tire by turning the hoist with the tire iron
• Put the tire iron into the storage compartment
• Put on the hoist cap
• Close the storage compartment