ARASP00025-Rear 2 Piece Generation II Air Spring Set

Replaces

Rear 2 Piece Generation II Air Spring Set Arnott ARASP00025

ARASP00025

Part Details

  • Product Line: Generation II
  • Set Quantity: 2 Piece
FREE SAME DAY SHIPPING
Save 30%
List: $349.95 Save: $105.00
Only 2 left in stock
Part ARASP00025
In Stock


Orders must be placed by 2pm ET
Delivery options for:

Estimated Arrival Cost


Deliveries made to PO Boxes and FPO may take longer. See our Shipping & Delivery for more information.

Arnott
Brand #: ARASP00025

Frequently bought together

Description
Vehicle Fit
Warranty & Shipping
How-To & Tools
Q&A

Part Details

  • Set Quantity:   2 Piece
  • Product Line:   Generation II

Item Condition: New

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

  1. step : Accessing the Compressor (0:43)
    • Open the fuse box
    • Disconnect the ECAS with a pair of pliers
    • Jack up the vehicle underneath the axle
    • Place jack stands underneath the rear frame rails
    • Take four sections of the jack pipe
    • Insert it into the rear hole, connect a tire iron, and turn it counterclockwise to lower the spare tire
  2. step : Disconnecting the Compressor (1:47)
    • Disconnect the wiring harnesses
    • Remove the harness clip from the frame
    • Push the hose in, push down on the connector, and pull the hose free
    • Remove the two 13mm bolts from the compressor
    • Pull the compressor down
    • Loosen the two hoses with a 10mm wrench
    • Release the air from the springs
    • Push the hoses in and tighten the fittings to 1 or 2 ft/lbs
    • Replace the two 13mm bolts and tighten them to the frame
  3. step : Removing the Air Springs (4:23)
    • Pull the bottom of the spring out
    • Push down and unlock the tab on the back of the spring and twist
    • Push the driver's side spring with a screwdriver and drive it with a hammer to release it
    • Pull the spring down
    • Disconnect the hose by pushing down on the fitting on the hose with pliers
  4. step : Installing the Air Springs (5:24)
    • Remove the plastic shipping piece on the tip
    • Open the top of the air spring using a 10mm wrench
    • Push the hose down into place
    • Tighten the 10mm nut
    • Twist the air spring into place
  5. step : Installing the Air Compressor (7:02)
    • Reconnect the two hoses and wiring harness
    • Clip the harness to the frame
    • Make sure both springs seat correctly to the axle as you lower the vehicle
    • Reinstall the ECAS control
    • Close the fuse box
    • Start up the vehicle to inflate the bags
    • Raise up the spare tire

Tools needed for replacement:

    General Tools

  • Floor Jack
  • Hammer
  • Jack Stands

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Torque Wrench

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 13mm Socket

  • Wrenches - Metric

  • 10mm Wrench

Need help? Ask one of our Auto Experts
Need help? Ask one of our Auto Experts
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
Approximately how long did the installation take?
Charles S February 17, 2016
The installation took one hour was very easy
Dan J February 17, 2016
Couple hours
Ranjeeta S February 17, 2016
Easy took only 40 mins for both sides was done in one hour,,,the box has instructions included
Matthew P February 17, 2016
The installation took around 1.5 hours. Much of this was due to dropping the spare which had a rusted cable and limited space to work on the air line connections. Just make sure to align the bags when dropping the vehicle
Wayne W February 17, 2016
It took about 2 and a half hours due to broken fitting at compressor otherwise not to bad. If I had to due over I would buy the kit to replace with shock absorbers.
William V February 18, 2016
took me about an hour, maybe less.......but i changed the pump also. Tip: In removing the old boots simply cut the airline as close down as you can to the boot fitting and pull the boots out. The new ones install just as easy because that freshly cut airline just pushes into the new fitting and clips itself into place. Its literally that easy.
Mark G February 18, 2016
45 minutes
Eric D February 18, 2016
It took about an hour, using a jack and jack stands in my driveway.
Darren A February 18, 2016
The installation was easier than I expected and it only took about 2 hours.
Neil D February 18, 2016
ETA can vary as we can see by the posts above. Appears to be approx 1-2 hrs job.
Brian F February 18, 2016
2 hours pretty easy job
Jim S February 18, 2016
Hi Charles, The install of the springs really didnt take that long, it was the hose connection that I had an issue with. The nipple that connects to the air line broke, so be-careful of that. Also re-installing the air line in the protective sleeve was a little tasking. Never the less job was accomplished and all are still working fine. Saved me a lot. Hope this helps. Good Luck C
Charles F February 21, 2016
IT TOOK 30 MINUTES BUT YOU KNOW THE MEC HAD TO TELL IT TOOK 2 HRS
Elizabeth A August 24, 2016
Less than 20 minutes to install
David F September 9, 2020

Fits the following Makes:

Year Make Model Description
2004-2007Buick Rainier Buick Rainier Rear 2 Piece Generation II Air Spring Set
2002-2009Chevrolet Trailblazer Chevrolet Trailblazer Rear 2 Piece Generation II Air Spring Set
2002-2006Chevrolet Trailblazer EXT Chevrolet Trailblazer EXT Rear 2 Piece Generation II Air Spring Set
2002-2009GMC Envoy GMC Envoy Rear 2 Piece Generation II Air Spring Set
2002-2006GMC Envoy XL GMC Envoy XL Rear 2 Piece Generation II Air Spring Set
2004-2005GMC Envoy XUV GMC Envoy XUV Rear 2 Piece Generation II Air Spring Set
2003-2008Isuzu Ascender Isuzu Ascender Rear 2 Piece Generation II Air Spring Set
2002-2004Oldsmobile Bravada Olds Bravada Rear 2 Piece Generation II Air Spring Set
2005-2009Saab 9-7X Saab 9-7X Rear 2 Piece Generation II Air Spring Set

Part Interchange

Brand Label Part Number
DIY Solutions SHO01881
DIY Solutions SHO01911

This item may be interchangeable with parts from other brands with the above part numbers. This information is provided only for reference and does not guarantee that the item you are purchasing is identical to parts with part numbers from the brands listed above. To confirm that this item fits your vehicle, use the above "Check Vehicle Fit" option.

FREE SAME DAY SHIPPING
Arnott
Brand #: ARASP00025
Product Reviews
5.00/ 5.0
2 reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
2
0
0
0
0
Good product and good transaction
Ordering and receiving the product were easy, received the product earlier than expected. Had it installed although the videos were very good. Now the ride is more stable than before.
March 14, 2017
AIR SPRING REPLACEMENT
AS PREVIOUSLY STATED... GETTING THE OLD ONES OUT IS THE HARD PART. ATTACHING THE HP HOSES TO THE NEW AIR SPRINGS WAS HARDER THAN INSTALLING THE AIR SPRINGS
October 25, 2017
Customer service

877-844-3393

Monday - Friday 8:00am - 9:30pm ET
Saturday - Sunday 8:00am - 4:30pm ET


Rear 2 Piece Generation II Air Spring Set Arnott ARASP00025-ARASP00025 does not fit your:


Before proceeding,

select your Vehicle, to verify this Part will fit.

This part will only fit a vehicle with these options.