Install Tip: You may be required to reset the vehicle computer after installation of this part.
Quality Tested - built to a strict level of product standards.
Item Condition:New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
How to Replace Mass Airflow Sensor 2007-12 Nissan Altima
How to Replace Mass Air Flow Sensor 2007-12 Nissan Altima
How to Replace Mass Air Flow Sensor 2004-15 Nissan Titan
How to Replace Mass Air Flow Sensor 2007-12 Nissan Altima
How to Replace Mass Air Flow Sensor 2003-2007 Infiniti G35
Created on:
Tools used
Locking Pliers
Phillips Head Screwdriver
Tools used
Phillips Bit in a Ratchet
Drill
Tools used
Phillips Head Screwdriver
1. Removing the Mass Air Flow Sensor
Disconnect the mass air flow sensor wiring harness
Remove the two Phillips head screws from the mass air flow sensor
Pull off the mass air flow sensor
2. Installing the New Mass Air Flow Sensor
Slide the new mass air flow sensor into place
Insert the two Phillips screws into the mass air flow sensor
Connect the mass air flow sensor wiring harness
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video we're going to show you how to replace a Mass Air Flow Sensor on this 2004 Nissan Titan and it's the same part and similar process on these Titans from 2004 to 2013. The only items that you're going to need for this are a new mass airflow sensor from 1AAuto.com and a Phillips screw driver.
Your mass airflow sensor is right here. Just push the tab on the harness and pull it free and then remove these two Phillip's screws. We'll just fast-forward as Don does that. Then, your mass airflow sensor pulls right out.
Take your new mass airflow sensor and push it into place. Then replace those two Phillip's screws and we'll just fast-forward again as Don tightens those up. Now reconnect your harness and you're all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
Tools used
Phillips Bit in a Ratchet
Drill
Tools used
1/4 Inch Ratchet
Gloves
10mm Socket
3/8 Inch Drive Ratchet
Safety Glasses
Product Reviews
Loading reviews
There are no reviews for this item.
Customer Q&A
No questions have been asked about this item.
Customer service
877-844-3393
Monday - Friday 8:00am - 9:30pm ET Saturday - Sunday 8:00am - 4:30pm ET
Nissan is a registered trademark of Nissan Motor Co., Ltd. 1A Auto is not affiliated with or sponsored by Nissan or Nissan Motor Co., Ltd.See all trademarks.
Enter Vehicle Year Make Model
Specify your vehicle's year, make and model to guarantee fit.
Year
Make
Model
Options
Drivetrain
This part doesn’t fit a . Select from parts that fit.