Mass Air Flow Sensor with Housing Walker Products 245-1107 - WKEAF00016

Walker Products Mass Air Flow Sensor: 245-1107

Walker Products, an ISO 9001-2008 / TS16949 certified company, specializes in the manufacturing and distribution of Fuel System Components and Automotive Engine Management products. Walker is committed to meeting or exceeding OEM or equivalent standards and specifications. This effort is backed by Walker's own manufacturing, product management and engineering expertise.

Specifications:

• Brand New Walker Mass Airflow Sensor
  • Not remanufactured
  • No core charge
• 5 pin Connector
• Direct replacement
• Built to strict quality control standards

Note: For 2007 truck models, the Classic Style has a crease down the center of the door skin where on the new body styles, the door skin is smooth. This part is for the Classic style truck.

Installation Notes:

This item is an electrical part. These units are tested prior to shipment.

Our electrical and electronic parts are subject to strict quality control testing. Please ensure proper diagnosis of this item before purchasing as the item cannot be returned once installed or plugged in.

Note:  You may be required to reset the vehicle’s computer after installation of this part.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Move the air intake tube out of the way. (1:00)

• Loosen the clamps and disconnect the tube with your screwdriver.
• Unclip the radiator hose.

step : Remove the air flow sensor (1:35)

• Disconnect the wiring harness.
• Remove the hose clamp and use a screwdriver to break the seal to pull off the air flow sensor.

step : Install the new airflow sensor (2:40)

• Transfer the seal ring to the new sensor.
• Mount the airflow sensor and tighten the clamp.
• Reconnect the wiring harness.
• Reconnect the intake tube and clip the radiator hose on.