Hyundai Kia VW Audi Vapor Canister Purge Solenoid Dorman 911-800 - 1AZMX00096

This Vapor Canister Purge Valve is a new part. It mounts on the engine and is used to control the flow of vapors from the EVAPORATIVE system to the intake manifold. It is controlled by the vehicles main computer or ECM. When the ECM sends the activation signal, a plunger in the valve will move to seal the vent. The ability to seal the vent is necessary for the on board diagnosis of other evaporative loss system components. This valve is used only for diagnosis, and usually remains opened. When the vent is closed, under normal purge conditions, the evaporative loss system is depressurized and allows "EVAP Control System (Small Leak)" diagnosis. If this valve is defective, the Check Engine Light will illuminate to Set with Small Leak Diagnosis. Some of the trouble codes associated with this part being defective are: P1456, P1448, P0449, and P0455.

Specifications:

• Brand new component
• Replaces dealer part numbers: 28910-22040, 2891022040, 06E906517A, 91354
• Engine mounted
• Direct replacement
• Built to strict quality control standards

Over time and daily use the valve can wear out causing the check engine light to set. If the valve is the problem, replace it now with this part.

Our electrical and electronic parts are subject to strict quality testing.

Parts cannot be returned after they have been installed. Contact us with any questions before installing the parts.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

step : Removing the Vapor Canister Purge Solenoid (0:38)

• Remove the engine cover
• Push the wiring harness forward, press the tab, and disconnect the wiring harness
• Pry off the clamp with hose clamp pliers or a flat blade screwdriver and pliers
• Pry and twist the hose off
• Remove the vapor canister purge solenoid
• Remove the adaptor

step : Installing the Vapor Canister Purge Solenoid (2:30)

• Insert the adaptor to the new vapor canister purge solenoid
• Slide the new clamp onto the hoses
• Insert the vapor canister purge solenoid into place
• Slide the clamp up into place and tighten it
• Reconnect the wiring harness
• Use a wire tie to resecure it and keep it in place if it feels loose