Ford Lincoln Mercury Fuel Injector 8 Piece Set DIY Solutions

These fuel injectors are just what you need to get your vehicle running great again!

Specifications:

• Comes as a Set of 8
• Brand New Fuel Injectors
• Replaces dealer part numbers: F0TZ9F593DA, F0TZ 9F593 DA, E5TE9F593A1A, E5TE 9F593 A1A, E5TE9F593A2A, E5TE 9F593 A2A, E5TE9F593A2B, E5TE 9F593 A2B
• Built to strict quality control standards
• Direct replacements
• 100% factory tested

These fuel injectors are great replacement and offers good cost savings over the dealer units.

Our electrical and electronic parts are subject to strict quality testing.

Parts cannot be returned after they have been installed. Contact us with any questions before installing the parts.

Your DIY Solution—Complete Repair in One Purchase

Do you need an assortment of parts to complete a repair? Stop searching for parts individually and complete your repair in a single purchase with a customized kit or set from DIY Solutions.

High-Quality Parts From Trusted Brands

Parts in DIY Solutions' kits and sets are selected from the best automotive brands and include hard-to-find and even obsolete parts you may need for your vehicle.

Guaranteed Fit

DIY Solutions ensures its selected parts are quality-tested to guarantee fit and function.

Item Condition: New

Attention California Customers:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

step : Removing the Fuel Injector (0:25)

• Release the fuel pressure by twisting off the Schrader valve cap
• Remove the two 10mm bolts from the fuel rail
• Pry the fuel rail and injectors up
• Disconnect the clip
• Remove the injector and check that it has its two O-rings

step : Installing the Fuel Injector (4:42)

• Place a bit of the right motor oil around the seal
• Insert the injector into the intake manifold
• Connect the wiring harness
• Press on the fuel rail
• Tighten the 10mm bolts to the fuel rail
• Tighten the Schrader valve cap