DORMAN POWER DOOR LOCK ACTUATOR: 746-148

This door lock actuator is designed to REPLACE a broken or missing unit.

Specifications:

• Brand New Dorman Door Lock Actuator
• Electrically operated
• Correct 2 prong plug electrical connection
• Direct replacement
• Built to strict quality control standards

This door lock actuator is a great replacement and has good cost savings over a dealer unit.

Our electrical and electronic parts are subject to strict quality testing.

Parts cannot be returned after they have been installed. Contact us with any questions before installing the parts.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

step : Remove the door panel (1:00)

• For more detailed instructions, see the 2006 Ford F150 door panel video

step : Remove the door lock actuator (1:50)

• Carefully peel back the water shield
• Remove the two plugs covering two 10 mm bolts in the side of the door
• Remove the bolts with your socket and ratchet
• Use your socket and ratchet to remove the nuts securing the door handle.
• Pull out the door handle, twisting it out and off the lock rod.
• Remove the T27 screws on the side of the door to uninstall the door lock actuator.
• Unbolt the window track to get it out of the way and unclip the door lock actuator cable.
• Pry off the rivet securing the lock rod and pull the actuator out.
• Unplug the wiring harness and unclip the door lock actuator from the assembly.

step : Install the new door lock actuator (5:40)

• Clip the new actuator to the door lock assembly and plug in the wiring harness.
• Thread the door lock mechanism back into the door and clip the lock rods in.
• Clip in the cable and the wiring harness.
• Bolt everything back in with your T27 Torx driver
• Bolt the door handle back in and plug in the little rubber seals in the side of the door.
• Replace the water shield and reinstall the door panel.
• For more detailed instructions on door panel re-installation, see our other videos.