Ford Lincoln Mercury Brake Light Switch - 1AZMX00027

Specifications:

• Mounts usually on brake pedal
• 6 blade terminal connection
• Replaces dealer part numbers: F87Z-13480-AA, F87Z13480AA
• Direct Replacement
• Built to strict quality control standards
• May also control the deactivation of the cruise control switch on same models

Our electrical and electronic parts are subject to strict quality testing.

Parts cannot be returned after they have been installed. Contact us with any questions before installing the parts.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

step : Diagnosis (1:00)

• Check the bulbs if one or more of your brake lights are still working.
• If none of them are working at all, you could have a bad brake switch or a blown fuse.
• To rule out a blown fuse, check your fuse box and use the manual to identify which fuses are responsible for the brake lights.
• If it’s not a bad bulb or blown fuse, you can go on to replace the brake switch.

step : Uninstall the old brake switch. (3:50)

• Under the dash, unclip the yellow clip securing the brake switch.
• Unplug the brake switch.
• Make sure not to lose the little bushing on the mounting, as they are prone to flying away.
• Unplug the brake switch from the wiring harness.

step : Install the new brake switch. (5:10)

• Plug in the new switch and secure with the little yellow plastic clip.
• Connect the wiring harness.
• Again, ensure all flying bushings are firmly where they should be and all small parts are accounted for.