Ford Driver Side Headlight DIY Solutions

Direct fit replacement for OEM assembly

Uses same wiring as original assembly.  No cutting or splicing required.

Meets federal regulations for on-road use

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

Bulb Note:

These lights do not include bulbs.  If you happen to receive a product with bulbs, the bulbs are for testing and not covered under our warranty.  Our warranty applies to the light assembly only.

step : Remove the headlight (1:17)

• Pop the hood.
• Pull up on the two tabs at the top of the headlight.
• Use a T20 Torx driver to remove the parking light.
• Remove the small Torx screw and pull the parking light out.
• Pull the headlight forward and out.
• Unplug the wiring connector and bulbs.

step : Install the new headlight (2:30)

• Transfer the bulbs into the new headlight assembly.
• Plug in the wiring harness.
• Fit the headlight and parking light assembly into place.
• Secure the parking light assembly with your T20 Torx driver.
• Clip the tabs down to secure the headlight.
• Close the hood.