Replaces
Ford Corner Light Pair - 1ALPP00989
1ALPP00989These replacement parking side marker lights are just what you need to get your vehicle in good looking form again!
Specifications:
- Comes as a PAIR
- Fits both LH (Driver Side) & RH (Passenger Side)
- Injection molded plastic
- DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
- Direct replacements
- Replaces dealer part numbers: 1L3Z-13201-BA, 1L3Z-13200-BA, 1L3Z13201BA, 1L3Z13200BA
- Correct for F-150 Lightning & Heritage models only
- Do not include bulbs or wiring
These parking side marker lamps are great replacements and have good cost savings over corner lights from the dealer.
Direct Fit Replacement
Direct fit replacement for OEM assembly
Trouble-free InstallationLight uses same wiring as the original assembly, providing easy, trouble-free installation. No cutting or splicing required.
DOT and SAE CompliantDOT & SAE compliant: meets federal regulations for on-road use
Lifetime Warranty
This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.
Bulb Note:
Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.
-
step : Remove the headlight (1:17)
- Pop the hood.
- Pull up on the two tabs at the top of the headlight.
- Use a T20 Torx driver to remove the parking light.
- Remove the small Torx screw and pull the parking light out.
- Pull the headlight forward and out.
- Unplug the wiring connector and bulbs.
-
step : Install the new headlight (2:30)
- Transfer the bulbs into the new headlight assembly.
- Plug in the wiring harness.
- Fit the headlight and parking light assembly into place.
- Secure the parking light assembly with your T20 Torx driver.
- Clip the tabs down to secure the headlight.
- Close the hood.
Tools needed for replacement:
- T20 Torx Driver
Torx Drivers & Sockets
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
Vehicle Fit
- 1997-2002 Ford Expedition Lightning Style Corner Light Pair
- 2004 Ford F150 Heritage Truck Lightning Style Corner Light Pair
- 1997-2003 Ford F150 Truck Lightning Style Corner Light Pair
- 1997 Ford F250 Light Duty Truck Lightning Style Corner Light Pair (Built After 7/96 Production Date)
- 1998-1999 Ford F250 Light Duty Truck Lightning Style Corner Light Pair
This part replaces:
- Partslink FO2521170, FO2520170