Door Lock Actuator 4 Piece Set

This is a 4 piece set of power door lock actuators that mount inside the doors. They are designed to REPLACE broken or missing units.

Door Lock Actuator Specifications

• Comes as a 4 piece set
• Electrically operated, not vacuum
• Correct electrical connection
• Anodized steel housing resists corrosion

These Power Door Lock Actuators are built to strict quality control standards. They are a great replacement and have substantial cost savings over dealer units.

Our electrical and electronic parts are subject to strict quality testing.

Parts cannot be returned after they have been installed. Contact us with any questions before installing the parts.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

step : Remove the door panel (1:12)

• Remove the two Phillips screws from the door pull
• Use a flat blade screwdriver to pry out the door handle bezel.
• Use a putty knife to carefully pry off the door panel and unclip the clips securing it.
• Pull off the panel and unplug all the wiring

step : Remove the door lock actuator (3:45)

• Carefully pull aside the plastic water shield
• Drill out the rivets securing the door lock actuator.
• Unclip the lock rods and unplug the wiring harness
• Transfer the mounting bracket and dust cover to the new lock actuator

step : Install the new door lock actuator (5:40)

• Use a couple coarse threaded bolts rather than rivets to re-install the door lock actuator
• Plug in the wiring harness and lock rods.
• Test your connections to make sure the doors lock and unlock properly.

step : Re-install the door panel (7:00)

• Put the water shield back into place.
• Reconnect the speaker and light.
• Thread the wiring harness back into place.
• Clip the door panel back on.
• Re-install the door handle bezel.
• Plug in the control panel.
• Bolt back in the door handle pull using your Phillips screwdriver.