Specifications:

  • Fits LH (Driver Side) Front
  • Direct fit replacement
  • Upgraded MDI (methylene diphenyl diisocyanate) material
  • Built to strict quality control standards

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Disconnecting the Battery (0:38)
    • Disconnect the negative terminal with a 10mm wrench
    • Let the vehicle sit for 30 minutes to let the airbag modules power down
  2. step : Removing the Seats (0:57)
    • Undo the two 15mm bolts at the front of the seat brackets
    • Remove the two 15mm bolts at the back of the rail
    • Spray the underside of the vehicle where the bolts are with rust penetrant if needed
    • Remove the seat belt cover
    • Remove the T45 Torx bolt from the seatbelt
    • Pull the seat back and buckle in the seat with the rear seat belt
    • Disconnect the electrical connector under the driver's seat
    • Disconnect the red safety tab from the wiring harness
    • Remove the four 13mm nuts holding the seat together
    • Remove the center seat
    • Remove the driver and passenger seats
  3. step : Removing the Seat Cushion (3:22)
    • Remove the four #2 Phillips screws from the seat
    • Remove the manual handle
    • Remove the three #2 Phillips screws from the other side
    • Pull out on the back cover and pry it off
    • Disconnect the switch wiring harness
    • Remove the three Phillips head screws
    • Remove the side cover
    • Unhook the plastic covers from the seat
    • Release the clips from the sides
    • Remove the seat cover and cushion
    • Disconnect the electrical connector and Velcro
    • Pull the seat up and out
    • Work the cover off of the cushion
  4. step : Installing the Seat Cushion (6:20)
    • Insert the seat cushion into the seat cover
    • Place the Velcro strap across the seat
    • Insert the seat cushion into place
    • Pull the heating pad harness through
    • Clip in the seat cushion
    • Connect the wiring harnesses
    • Insert the side cover wiring harness
    • Insert the side cover into place
    • Tighten the four #2 Phillips screws to the seat
    • Place the other panel into its position
    • Tighten the three #2 Phillips screws on the other side
  5. step : Installing the Seats (3:58)
    • Insert the seats into place
    • Leave them laid back
    • Tighten the 13mm bolts the center console onto the passenger seat
    • Clip the wiring harness into place
    • Connect the wiring harness
    • Lay the seats back down and align the bolt holes up
    • Tighten the 15mm bolts to the front of the seat
    • Tighten the 15mm bolts to the back of the seat
    • Torque the seat bolts to 30 foot-pounds
    • Insert the seatbelt tab into place
    • Tighten the T45 bolt into the seat belt
    • Torque the bolt to 29 foot-pounds
    • Press in the seatbelt cover
  6. step : Connecting the Battery (6:54)
    • Tighten the 10mm negative battery terminal

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • Rust Penetrant

  • Pliers, Cutters & misc Wrenches

  • Bent Nose Pliers

  • Ratchets & Related

  • Ratchet
  • Torque Wrench
  • Socket Extensions

  • Screwdrivers & Related

  • No. 3 Phillips Screwdriver
  • Flat Blade Screwdriver
  • No. 2 Phillips Screwdriver

  • Sockets - Metric

  • 10mm Socket
  • 15mm Socket
  • 13mm Socket

  • Torx Drivers & Sockets

  • T45 Torx Socket

4.9 / 5.0
17 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
16
1
0
0
0
Better seat cushion
Using the video from 1A Auto made installation very easy. Fit great and at first appearance and feel, is better than the original. Better yet, there is a lifetime warranty on this product. With Dodge's history of eating these seat cushions, this may prove it's self a good investment. Very happy with the service and shipping from 1A Auto.
January 22, 2017
Purchased
1 year ago
Dodge Ram Driver seat foam
I've owned my Dodge since new in 2006. It's been a great truck and over the years have replaced a variety of parts over the years, mostly using oem parts. This seat cushion replacement was a definite upgrade from oem. Top quality. I used another online video that showed how to replace without removing the entire seat. Took me two tries to get it right, but now it's perfect. The little flap on the backside is a little tricky, but what a great improvement.
November 6, 2017
Purchased
4 months ago
Best Value, best price, fastest deliver, excellent quality
I extensively researched suppliers for quality seat cushion replacement for my 2005 Dodge Ram and found 1AAuto to have the best cushion at the best price. As always, delivery times are superb. The ride is so much more comfortable than even the factory seats. Installation was a breeze with no surprises. Thanks 1AAuto!
October 26, 2017
Purchased
4 months ago
Dodge drivers seat cushion
New sear cushion worked perfect. Cushion came off without taking seat out. U tube videos were spot on
December 18, 2017
Purchased
3 months ago
great
product was great .had a great fit
. it was easy to do even for an old guy.
March 22, 2017
Purchased
11 months ago
Very happy with seat cushion and 1a
Much better product than oem cushion. Fits like a glove and was extremely easy to install.
March 29, 2017
Purchased
11 months ago
Perfect fit, great value, highly recommended. Check youtube, you don't have to pull the seat to replace the cushion. Mine took about an hour and was easy peasy.
September 1, 2017
Purchased
6 months ago
Wish I didn’t wait so long!
I replaced the old worn down seat cushion with this replacement and it was worth every penny and only took me about 30 min to swap them out. I didn’t realize how bad my old cushion was until I sat on this one and I would recommend it to anywone! Great fit with easy install without removing seat!
October 16, 2017
Purchased
4 months ago
Ram 1500 driver seat fusion - easy install
Great fit, super easy to install in my 2006 Ram 1500. If you are careful, you don't need to remove the seat from the truck! Take your time and watch the 1-A Auto video before you start, that way you know what to expect when you get it apart.
October 8, 2017
Purchased
5 months ago
Perfect replacement!
Very easy to replace the worn original cushion. Made me happy to sit in my truck again. The experience outweighs the words by miles...
March 1, 2017
Purchased
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 2 questions Browse 2 questions and 3 answers
Will this work with leather seats?
Mike G on Mar 23, 2017
BEST ANSWER: I have leather on my 2007 dodge 2500 crew cab and it worked fine.
Is the Upgraded MDI foam better quality than stock? Will it last longer than stock?
Richard S on Dec 21, 2016
BEST ANSWER: Yes, the MDI foam material used for this seat is meant to be an upgrade to the stock seat cushions, and ensure a longer life expectancy.

How-to Video:

(12:21 min)

Tools List:

    Materials, Fluids, and Supplies

  • Rust Penetrant

  • Pliers, Cutters & misc Wrenches

  • Bent Nose Pliers

  • Ratchets & Related

  • Ratchet
  • Torque Wrench
  • Socket Extensions

  • Screwdrivers & Related

  • No. 3 Phillips Screwdriver
  • Flat Blade Screwdriver
  • No. 2 Phillips Screwdriver

  • Sockets - Metric

  • 10mm Socket
  • 15mm Socket
  • 13mm Socket

  • Torx Drivers & Sockets

  • T45 Torx Socket



This part replaces:

  • OE # 5180021AA

Vehicle Fit

  • 2006-2008 Dodge Ram 1500 Truck Front Seat Cushion Bottom Upgrade for Models with Cloth Seats Driver Side excluding Occupant Classification System
  • 2006-2008 Dodge Ram 1500 Truck Front Seat Cushion Bottom Upgrade for Models with Vinyl Seats Driver Side excluding Occupant Classification System
  • 2006-2009 Dodge Ram 2500 Truck Front Seat Cushion Bottom Upgrade for Models with Vinyl Seats Driver Side excluding Occupant Classification System
  • 2006-2009 Dodge Ram 2500 Truck Front Seat Cushion Bottom Upgrade for Models with Cloth Seats Driver Side excluding Occupant Classification System
  • 2006-2009 Dodge Ram 3500 Truck Front Seat Cushion Bottom Upgrade for Models with Cloth Seats Driver Side excluding Occupant Classification System
  • 2006-2009 Dodge Ram 3500 Truck Front Seat Cushion Bottom Upgrade for Models with Vinyl Seats Driver Side excluding Occupant Classification System
Part #: 1AISU00513

Ships Same Day for orders placed by 4 P.M. ET

We're here to help

1A Auto Parts

Customer Feedback

"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More