Dodge Dakota Durango Wheel Bearing & Hub Assembly Front Timken HA599361 - TKSHF00091

TIMKEN WHEEL BEARING & HUB ASSEMBLY: HA599361

This replacement hub & bearing assembly is just what you need to get your vehicle in good working order again.

Specifications:

• Brand New Timken Wheel Bearing & Hub Assembly
• Fits either LH (Driver Side) or RH (Passenger Side) FRONT
• 3 Bolt Flange
• Fits 6 Lug Wheel
• Replaces dealer part numbers: 52069361AB, 52069361AC
• Direct replacement
• Built to strict quality control standards
• New wheel studs installed
• Fits 4WD (Four Wheel Drive) Models only
• Fits models with RWAL (Rear Wheel Anti-Lock Brakes) only

Note:
These parts are authentic Timken brand products that are supplied and packaged by Timken.   In some cases, Timken will source parts from other high quality suppliers such as SKF and Koyo. These parts are subjected to the very same testing and quality standards as all Timken products.

Item Condition: New

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the Wheel (1:10)

• While your car is still on the ground, use your 32mm socket to loosen the center hub nut
• Loosen your lug nuts and jack up the car
• Remove the lug nuts with your 19mm socket and ratchet
• Remove the wheel and set aside

step : Removing the Brakes (1:20)

• Remove the T47 torx bolts holding the calipers and the bracket
• Wire tie the caliper up and out of the way, set the bracket to the side
• Remove your rotor and set aside

step : Removing the Axle (1:56)

• Remove the 14mm bolts securing the axle
• Use an axle puller or a light, but firm, tap with a small hammer on the axle to remove it

step : Remving the Hub (5:30)

• Remove the three 22 mm bolts, using penetrating oil to help
• A breaker bar or piece of pipe on the end of your ratchet may be needed
• Remove the hub and clean the area with a wire brush

step : Replacing the Hub (7:20)

• Clean hub seating with a wire brush and add a little anti-seize grease
• Put position your new 1A Auto hub in its seating
• Put the three 22 mm bolts in place and tighten the nuts to 90 ft lbs
• Reinstall the axle and torque the 14 mm bolts to 60 ft lbs

step : Reinstalling the Brakes and Wheel (8:45)

• Refer to our other videos for more detailed instructions
• Remember to replace the lug nuts on in a star pattern
• Lug nuts tighten to 90-100 ft lbs
• Hub nut is 175 ft lbs
• Make sure to check your brakes and steering before driving again
• Make sure to have the vehicle aligned