Chevy Monte Carlo Tail Light - 1ALTL00953

This is a direct replacement tail light for your vehicle. It installs just as your original does. If your tail lamp has been damaged broken or cracked this light is your answer.

Specifications:

• Passenger Side
• Replaces dealer part numbers: 15913299
• Department of Transportation (DOT) & Society of Automotive Engineers (SAE) approved
• Bulbs and wiring not included

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

Direct fit replacement for OEM assembly

Uses same wiring as original assembly.  No cutting or splicing required.

Meets federal regulations for on-road use

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the Tail Light (0:36)

• Twist and remove the thumb screw in the trunk
• Pull down the insulation
• Twist and remove the thumb screws on the back of the tail light
• Pull the tail light out

step : Servicing the Bulbs (1:10)

• Twist the bulb socket counterclockwise out of the light
• Pull the bulb off of the socket
• Push on the new bulb
• Twist the bulb clockwise into the light

step : Preparing the New Tail Light (2:05)

• Removing the packing stickers
• Twist the sockets back into the tail light
• Re-clip the harness into the tail light bracket
• Make sure no wires are in front of the studs

step : Installing the New Tail Light (3:06)

• Line up the studs and push the tail light into place
• Replace the thumb screws
• Replace the insulation
• Replace the thumb screw inside the trunk