DORMAN EXHAUST MANIFOLD & GASKET KIT: 674-217 & 674-218

Specifications:

• Brand New Dorman Exhaust Manifold Kits
• Comes as a PAIR
  • Fits both LH (Driver Side) & RH (Passenger Side)
• LH Kit Includes:
  • Heat Shield
  • Gaskets
  • Studs (Qty 3)
  • Nuts (Qty 3)
  • Springs (Qty 3)
• RH Kit Includes:
  • Gaskets (Qty 3)
  • Studs (Qty 3)
  • Nuts (Qty 3)
• 3 bolt flanges
• Direct replacements
• Strengthened and redesigned in the vulnerable areas of failure

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Nickel (Metallic), which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the Exhaust Manifold (0:48)

• Start the vehicle
• Keep your hands away from the hot engine
• Crack loose the six bolts on the exhaust manifold
• Remove the three 13mm bolts around the flange where the exhaust meets the exhaust manifold
• Disconnect the connector for the O2 sensor
• Remove the exhaust manifold

step : Installing the Exhaust Manifold (4:38)

• Place appropriate high temp threat locker on the short side of the stud
• Start the threads by hand to the flange
• Tighten the nut so the edge faces out
• Once it's tightened two times the length of the nut, tighten a second nut so they face eachother
• Lock the nuts together
• Turn the nut to install the stud until it bottoms out
• Remove the nuts
• Repeat this process for the remaining studs
• Place the thread locker and new gaskets into place
• Insert the exhaust manifold to the mating surface
• Hand-tighten the six bolts a few threads to support the manifold
• Torque the two center bolts to 26 foot-pounds
• Tighten the three 13mm bolts to the flange
• Connect the O2 sensor connector
• Tighten the six bolts to the exhaust manifold