Chevy Dodge GMC Front Brake Caliper Set Raybestos Opti-Cal FRC4414N, FRC4413N - RABCS00037

Raybestos Opti-Cal New Brake Caliper

• Designed to match OE specifications
• Made with 100 percent newly manufactured materials, offering unparalleled style and performance
• Zinc plated or aluminum, delivering superior corrosion resistance in the harshest of elements
• Rigorously tested to ensure a safe, reliable performance after thousands of miles
• Friction-ready, giving you the freedom to customize the brake pads for each application

Item Condition: New

Attention California Customers:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Remove wheel. (1:11)

• Remove hub cap or center cap if you have it.
• While your car is still on the ground, use your 22mm socket to loosen your lug nuts.
• Jack up and secure your car with jack stands.
• Remove the lug nuts with your 22mm socket and ratchet.
• Remove the wheel and set aside.

step : Remove the calipers (1:35)

• Use a screwdriver to force the pistons back in.
• Remove the two 3/8 Allen bolts to remove the calipers.
• Use a wire tie to fasten the caliper out of the way.
• Use your screwdriver to pry out your brake pads.
• Remove the caliper bolt sleeves.
• Check their condition and clean them with a wire brush if necessary.
• Compress the caliper piston with a c-clamp.
• Pull off the brake rotor.
• Hit the rotor with a rubber mallet or hammer if necessary.
• Take care not to damage the lug studs.

step : Install new rotor and pads (7:15)

• Clean new rotor with brake cleaner.
• Insert your new pads into the brackets.
• Put your caliper bracket back on, and tighten the 3/8 Allen bolts to 25-30 ft lbs.

step : Put wheel back on (9:42)

• Make sure to use a star pattern when putting your wheel lugs back on.
• Tighten to 100-120 ft lbs.
• Replace hubcap/center cap.

step : Test and set brakes (10:08)

• Before driving the car again, start it up and pump the brakes a few times to get the pistons in the brakes in place.
• Test the brakes in your driveway before taking the car onto the road.
• Set your rotors by evenly braking from 30mph to 10mph, 50mph-30mph and finally 70mph to 40mph.
• This is best done on a straight back road without any traffic.