Replaces
Replaces Chevrolet GMC Cadillac Front Driver & Passenger Side 2 Piece Strut & Spring Assembly Set Arnott ARASP00069
$1,427.95
Replaces Chevrolet GMC Cadillac Front & Rear 5 Piece Suspension Kit TRQ PSA52596
$1,209.95
Replaces Chevrolet GMC Cadillac Front & Rear 8 Piece Suspension Kit TRQ PSA52595
$984.95
Replaces Chevrolet GMC Cadillac Front & Rear 4 Piece Complete Shock Assembly & Shock Absorber Kit TRQ SKA33135
$909.95
Replaces Chevrolet GMC Cadillac Front Driver & Passenger Side 2 Piece Magnetic Ride Control Strut Assembly Set Arnott ARASP00070
$819.95
Replaces Chevrolet GMC Front Driver & Passenger Side 2 Piece Strut & Spring Assembly Set Truck-Plus Leveling Assembly KYSSP00534
$799.95
Replaces Chevrolet GMC Cadillac Front 7 Piece Steering & Suspension Kit TRQ PSA66945
$754.95
Replaces Chevrolet GMC Cadillac Front Driver & Passenger Side 3 Piece Steering Kit TRQ PSA58578
$729.95
Attention California Customers:
WARNING: This product can expose you to chemicals including Acrylonitrile, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
This item ships directly from supplier.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the accelerator pedal and the pedal also has a position sensor in it. This is a 2011 Chevy Silverado. This is the same for many GM trucks and SUVs of this time period, basically 2007 to 2013.
For a pedal that's going bad, you can have hesitation in your vehicle where it's not quite getting full power and things like that. Even if a sensor really goes bad, then all your traction control and service ABS and all that stuff, all your lights will start flashing. You'll need a new accelerator pedal and sensor from 1AAuto.com, a 10 millimeter socket, T30 Torx driver or socket, and a ratchet and extension.
To start off, your battery is located on the passenger side, rear of the truck. You want to disconnect the negative battery cable, loosen up that 10 millimeter nut, and pull that cable up and off and set it off to the side where it won't contact the battery post.
Most of you should know where the accelerator pedal is. It's held in by two T30 Torx screws, one there and then there is one basically opposite of it on top as well. Disconnect the lead by pulling out on the grey clip. Just work your fingernail under there and pull it back, then press the clip on the side. There's a tab on the side, press it in and pull the connector off. Then using a T30 Torx bit, I'm using a socket and ratchet, you could also use just a T30 Torx driver, remove the two bolts that hold these simply in place.
The new assembly from 1A Auto is going to be just like the old assembly. There are two tabs in the back that line up into holes in the mounting surface. Make sure those are lined up. Hold them in place. I found it easy just to start the top one first, get in a few turns, and then the lower one I kind of loaded to my Torx bit, inserted it into place, and started it. Tighten those up. You want to tighten them nice and firm; don't over-tighten them you don't want to strip the plastic out. Re-connect your negative battery cable by just reaching in there. Put it back on the post, push it down firmly, and then re-tighten that 10 millimeter nut.
Thanks for tuning in. We hope this video helped you out. Next time you need parts for your car, please visit 1AAuto.com. Also check out our other helpful how-to and diagnosis videos.
