BMW Radiator Fan Clutch TRQ RCA91843

1. step 1 : Disconnecting the Battery 0:25

   • Loosen the 10mm nut on the negative terminal
   • Disconnect the negative terminal

2. step 2 : Removing the Air Intake Duct 0:54

   • Pry up the clips from the air intake
   • Remove the air intake duct

3. step 3 : Removing the Radiator Fan and Fan Shroud 1:18

   • Disconnect the electrical connectors
   • Remove the T25 bolt from the fan
   • Pry out the push clip from the fan shroud
   • With a 32mm fan clutch tool and pneumatic air hammer, loosen the fan clutch from the engine side
   • Once loose, spin the fan off without letting it fall
   • Remove the fan and fan shroud

4. step 4 : Removing the Radiator Fan Clutch 4:28

   • Remove the bolts from the fan and the fan clutch with a 5mm hex socket
   • Remove the fan clutch

5. step 5 : Installing the Radiator Fan Clutch 5:32

   • Connect the fan clutch to the fan
   • Tighten the three 5mm hex bolts to the fan
   • Torque the bolts to 89 inch-pounds

6. step 6 : Installing the Radiator Fan and Fan Shroud 6:27

   • Insert the fan and fan shroud simultaneously
   • Tighten the fan to the engine side with a 32mm fan clutch tool and pneumatic air hammer
   • Torque the fan nut to 22-29 foot-pounds
   • Press the push-pin to the fan shroud
   • Tighten the T25 Torx bolt to the fan
   • Connect the two electrical connectors

7. step 7 : Installing the Air Intake Duct 8:22

   • Insert the air intake duct into place
   • Press in the clips to the air intake duct

8. step 8 : Connecting the Battery 8:44

   • Connect the negative terminal
   • Tighten the 10mm bolt to the negative terminal

Tools needed

• 5mm Hex Wrench

  Torque Wrench

  Fan Clutch Wrench

  10mm Wrench

  3/8 Inch Air Impact Gun

  T25 Driver