2007-09 Chevy Equinox Lighting Kit - 1ALHT00192

• Brand New Lighting Kit
• Comes as a 4 Piece Kit
  • Fits LH (Driver Side) & RH (Passenger Side)
• Direct replacements
• Built to strict quality control standards

Direct fit replacement for OEM assembly

Uses same wiring as original assembly.  No cutting or splicing required.

Meets federal regulations for on-road use

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Bulb Note:

These lights do not include bulbs.  If you happen to receive a product with bulbs, the bulbs are for testing and not covered under our warranty.  Our warranty applies to the light assembly only.

step : Removing the Headlight (1:03)

• Remove the center bar using a flat blade screwdriver to pry out the clips on the back
• If one of the edge clips breaks replace it with one of the center clips
• Remove the two 8mm bolts at the top
• Remove the 10mm bolt down on the side of the light
• Pull up on the tab on the back of the headlight
• Grab the bottom edge of the headlight and pull out
• Disconnect the wiring harnesses by pressing on the tabs

step : Changing Headlight Bulbs (4:05)

• Twist the ring off
• Pull the bulb out
• Push the bulb back into place and replace the ring
• For the smaller bulbs twist them counterclockwise and pull out the bulb
• Replace by twisting clockwise

step : Replacing the Headlight (5:11)

• Reconnect the wiring harnesses
• Put the light down and in, making sure the wires go down below the metal support
• Push the light back into place.
• Put the two 8mm bolts back into place
• Put the 10mm bolt back into place
• Replace the center bar by snapping the clips back into place