2004 Chrysler Pacifica Passenger Side Headlight DIY Solutions

Direct fit replacement for OEM assembly

Uses same wiring as original assembly.  No cutting or splicing required.

Meets federal regulations for on-road use

Item Condition: New

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

Bulb Note:

These lights do not include bulbs.  If you happen to receive a product with bulbs, the bulbs are for testing and not covered under our warranty.  Our warranty applies to the light assembly only.

step : Removing the Headlight Assembly (1:17)

• Remove the two 8mm bolts at the top of the headlight.
• Push the bumper cover down and reach underneath the light and pull on the light.
• Remove the headlight assembly.
• Push the thumb tab on the harness attached to the headlight assembly and disconnect.

step : Changing the Headlight Bulbs (2:17)

• Remove the rubber cover.
• Reach in and twist the light counterclockwise.
• Pull the bulb out.
• Replace it and avoid touching the glass part.
• Insert the light and twist clockwise to lock it.
• The other bulbs need to be twisted counterclockwise to remove and replace the bulbs.

step : Replacing the Headlight Assembly (3:33)

• Remove the clip from the old headlight assembly by pressing the tabs and pulling it through.
• Put the clip onto the new harness on the new headlight assembly.
• Clip the harness in place.
• Connect the headlight harness
• Line the headlight up and push it into place.
• Replace the two 8mm bolts at the top of the headlight.

step : Adjusting the Headlights (6:11)

• Park 20' from a wall on a flat surface.
• Turn the adjusting bolt clockwise to aim the light down and counterclockwise to angle it up.
• The low beam concentration should be 1" lower than the bulb.
• The high beam concentration should be at the same height as the bulb.