Replaces
This part doesn’t fit a . Select from parts that fit.
1A Auto Lifetime Warranty
Part Details
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace a rear outside door handle on this Chevy Colorado. It's a pretty easy procedure. We show you the driver side. The passenger side is the same. You'll need a Phillips screwdriver and a 10mm socket with a ratchet and extension or actually a 10mm wrench would work and you'll also need a flat blade screwdriver.
First, there's two Phillips screws down there, remove those, and you'll also remove a Phillips screw right in there. We'll fast-forward here as I remove those three screws. Okay, once you pull this up there's a little button right here, just disconnect that harness. Start down here and pull firmly around and the panel comes off, up, and out.
You'll want to slowly and carefully peel the top corner of the water shield back so you can access the upper inside of your door. As you come in, there are two bolts that hold it in. One you can access right through there and the other one is right there, as well as there's a red clip on the rod that you can use a screwdriver. Work a screwdriver in there, pry the clip up and off and then use it to knock the rod out of the door handle. I'm going to fast forward here as I use a 10mm socket with a ratchet and extension to reach in and get those two bolts out that hold the door handle on. On the handle, you want to lift up on the inside and bring it right out.
I can actually, now, put the handle in place and clip it in place. Get these bolts. I'm going to load them into my socket, put them right in and get them going. Do the same thing over here. Load the bolt into the socket. Put it right in. Get the rod going in and put the clip up slide the rod all the way in and then just use my finger and clip the clip on.
Now, with the door panel, make sure it's up on the windowsill here against the window. Make sure our wire's through. Kind of peek back in, you see the clips go in. Okay, right around. We can plug our switch back in. Clip the bezel right back down and on. Put this one right back in place. We'll fast-forward here again as we tighten up those screws; like to tighten them up nice and firm. You don't want to make them too tight, you could break some of the plastic, but you want them nice and firm so that your door feels nice and solid when you open and close it.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
