2004-06 Nissan Maxima Headlight - 1ALHL01348

Warranty & Shipping
How-To & Tools
Product Reviews
Vehicle Fit

Part Details

  • Light Option:   Halogen


  • LH Driver Side
  • Replaces dealer part numbers: 26060-ZA80A, 26060ZA80A
  • Includes lens and housing
  • Bulbs not included
  • Halogen Style
    • Not correct for Xenon (HID) lights

    Due to changes in the manufacturing process, these housings use H9 bulbs for the low beams instead of the factory 9012. There are no modifications required and the factory wiring will fit correctly without issue

Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Uses same wiring as original assembly.  No cutting or splicing required.

DOT and SAE Compliant

Meets federal regulations for on-road use

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Bulb Note:

These lights do not include bulbs.  If you happen to receive a product with bulbs, the bulbs are for testing and not covered under our warranty.  Our warranty applies to the light assembly only.

  1. step : Removing the Bumper Cover (0:51)
    • Remove the two black clips from both sides of top of the bumper.
    • Remove the two Phillips screws underneath the bumper in front of the wheels.
    • Pull the inner fender back.
    • Find the wiring harness inside the fender and pull the tab to disconnect it.
    • Remove the two 10mm bolts inside the inner fender.
    • Remove the series of six pins underneath the front bumper.
    • Pull firmly on each side and lift and pull the bumper cover forward.
  2. step : Removing the Headlight (3:49)
    • Remove the five 10mm bolts around the headlight.
    • Pull the light forward, up and out.
    • Press firmly on the tab and pull the wiring harness free.
  3. step : Changing Headlight Bulb (4:40)
    • Turn headlight cap counterclockwise and pull out.
    • Press the locks in towards the center of the light.
    • Pull the bulb out. (Do not touch the glass of the new bulb).
    • Press down and turn counterclockwise to free the old bulb.
    • Push new bulb in and turn clockwise
    • Put socket into place and latch the locks.
    • Reapply headlight cap by lining up tabs and locking it into place.
  4. step : Changing Turn Signal Bulb (6:10)
    • Twist the socket counterclockwise to release it.
    • Push bulb down and out.
    • Push new bulb in.
    • Turn clockwise to lock.
  5. step : Changing Fog Light (6:32)
    • Twist socket cap counter clockwise and pull out.
    • Push latch on light down and pull the socket free.
    • Free bulb from cap.
    • Carefully pull the bulb free.
    • Push new bulb into place and reconnect to cap.
    • Line the round cut out with the bottom and place the socket into place.
    • Bring the latch down to lock it.
    • Twist the cap clockwise to lock.
  6. step : Replacing the Headlight Assembly and Bumper Cover (8:31)
    • Reconnect the light harness and line up the headlight.
    • Lock it into place and reinsert the five 10mm bolts.
    • Test Headlight.
    • Line up the bumper cover and push it into place.
    • Push the two clips back in on top.
    • Lift the bottom panel up and over. Replace the six clips.
    • Reach up into the fender and replace the two bolts.
    • Reinstall the wiring harness.
    • Reinstall the Phillips screws under bumper cover.

Tools needed for replacement:

    General Tools

  • Flashlight

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

There are no reviews for this item.
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Year Make Model Description
2004-2006Nissan Maxima Nissan Maxima Halogen Headlight Driver Side
Part #: 1ALHL01348

Order must be placed by 4pm ET
Delivery options for:

Estimated Arrival Cost

Deliveries made to PO Boxes and FPO may take longer. See our Shipping & Delivery for more information.

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(12:37 min)