Specifications:

  • Brand New Tie Rod Ends
  • Comes as a Set of 4
    • Fits LH (Driver Side) & RH (Passenger Side)
  • Direct replacement
  • Built to strict quality control standards

Our steering and suspension components are sealed for long life and do not require the extra maintenance typically required by greasable versions.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Part Details

  • Quantity: 4 Piece Set

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

    We recommend an alignment after completing this repair

  1. step : Removing the Wheel (0:49)
    • Loosen the 19mm lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Outer Tie Rod (1:20)
    • Loosen the 24mm lock nut with a 21mm wrench and hammer
    • Make note of how far you turn the inner tie rod to turn it back for reinstallation
    • Remove the 24mm nut from the outer tie rod end
    • Remove the cotter pin with needle nose pliers
    • Remove the ball joint nut
    • Strike the steering knuckle with a hammer to loosen the outer tie rod
    • Twist off the outer tie rod by hand
  3. step : Installing the New Outer Tie Rod (3:27)
    • Twist the new outer tie rod onto the inner tie rod
    • Push the outer tie rod into the steering knuckle
    • Fasten the castle nut onto the outer tie rod
    • Tighten the castle nut to 32 foot-pounds
    • Push the cotter pin through the castle nut
    • Twist the cotter pin into place with needle nose pliers
    • Make sure the inner tie rod is in its correct position
    • Hold the tie rod with an 18mm wrench
    • Tighten the 24mm lock nut
  4. step : Reattaching the Wheel (5:32)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the 19mm lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 80 foot-pounds in a crossing or star pattern

Tools needed for replacement:

    General Tools

  • Hammer

  • Materials, Fluids, and Supplies

  • Rust Penetrant

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Torque Wrench
  • 1/2 Inch Breaker Bar

  • Sockets - Metric

  • 24mm Socket
  • 17mm Socket

  • Wrenches - Metric

  • 21mm wrench
  • 24mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

Year Make Model Description
2003-2011Honda Element Honda Element Front Inner & Outer Tie Rod 4 Piece Set

This part replaces:

  • Moog EV800242
  • OE # 53541S7A003
  • OE # 53521SCVA01
  • Moog ES80995
  • Beck Arnley 101-6422
Part #: 1ASFK02898

Out of Stock

How-to Video:

(06:17 min)