2003-11 Honda Element Strut & Spring Assembly - 1ASSP01075

In the past, replacing struts required specialized tools to compress, remove and transfer the old spring and mount.  Pre-assembled with all new parts, our complete strut and spring assemblies make this job much quicker and easier for the do-it-yourself mechanic.

Each complete strut & spring assembly contains:

  • Upper Strut Mount
  • Strut Bearing
  • Coil Spring
  • Boot & Bumper Kit
  • Gas-charged Strut 

Pre-assembled, loaded strut & spring assemblies allow for a quicker, safer install than replacing with just bare struts. 

Trouble-Free Install

Trouble-free install includes the matched parts needed to get the job done. New mounts, bearings, springs and hardware will provide a better ride for your vehicle and save you time from not having to do the job again because a used part failed afterwards.

Matched Parts

When you buy the kit pre-built by us, you can be sure that the parts are matched for optimum performance.  Not all shocks and struts are manufactured the same, so mixing and matching can result in fit issues and potentially decrease the life of the parts.

Saves Time & Money

When you buy one of our kits, you not only save money over buying the parts individually, but you also save time having to search for all of the different parts that are correct for your vehicle (because we did it for you!)

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Wheel (0:58)
    • Loosen the 19mm lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Stabilizer Link (1:35)
    • Turn the wheel by hand
    • Clean off the threads with rust penetrant and a wire brush if necessary
    • Hold the lower stabilizer link stud with a 14mm wrench
    • Remove the nut from the stabilizer link with a 15mm hex socket
    • If the nut strips out, hold it in place with locking pliers and sawzall it off
  3. step : Reinstalling the Stabilizer Link (3:41)
    • Push the stabilizer link into place
    • Start the nuts by hand
    • Tighten the nuts
    • Torque the nuts to 29 foot-pounds
  4. step : Reattaching the Wheel (4:19)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the 19mm lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 80 foot-pounds in a crossing or star pattern

Tools needed for replacement:

    Allen Wrenches

  • 5mm Allen Wrench

  • General Tools

  • Sawzall

  • Ratchets & Related

  • Ratchet
  • Socket Extensions
  • 1/2 Inch Breaker Bar

  • Sockets - Metric

  • 19mm Socket

  • Wrenches - Metric

  • 14mm Wrench

4.3 / 5.0
3 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
So far so good
I was having a little difficulty finding the parts I needed. A-1 had what I needed. Order was a breeze and delivery was prompt. I had a mechanic install the parts and my Element's ride is now noticeable better - nice & smooth.
May 11, 2018
1 month ago
Beat up packaging mismatched part numbers
I ordered parts for two different but similar vehicles and none of the numbers on the boxes match the part numbers on my order. Hard to figure out which pets went where before taking the others off the vehicle. Packages were destroyed with damage to strut assemblies which may or may not have happened during shipping. Prices were great and because of that I would order from them again. Shipping was also cheap and quick.
December 4, 2017
6 months ago
Response from 1A Auto
Thank you for your review! We are sorry you are tunning into this issue. If you give us a call, we can identify the parts you received by they part numbers on the packaging. We would be more than happy to help you with this! Thank you!
December 4, 2017
Adam G Staff
October 19, 2017
7 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2003-2011 Honda Element Front & Rear Strut & Spring Assembly 4 Piece Set

This part replaces:

  • Hollander 527-60200L
  • OE # 51602SCVA17, 51602SCVA07
  • Hollander 527-60199R
  • OE # 51601SCVA17, 51601SCVA07
  • Hollander 527-60202L
  • Hollander 527-60201R
  • OE # 52620SCVA03
  • OE # 52610SCVA03
  • Monroe 172136
  • Monroe 172135
  • Monroe 171101L
  • Monroe 171101R
Part #: 1ASSP01075

How-to Video:

(05:14 min)