2000-06 Nissan Sentra Blower Motor Resistor - 1AHBR00022

This heater blower motor resistor is a new, aftermarket replacement part. It is just what you need to bring your heating and A/C blower system back to good working order! On most vehicles it is mounted to the HVAC unit inside the passenger compartment. It can be accessed from the passenger foot well area.


  • New, not remanufactured or rebuilt
  • Direct replacement
  • Replaces dealer part numbers: 27150-6Z500, 271506Z500
  • Built to strict quality control standards
  • 100% tested prior to leaving the factory
  • 4 terminal connection
  • 4 Mounting holes
  • Fits all models

If you are experiencing intermittent stopping during use or the fan only works in one position this may be your solution!

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed

Left Hand Drive Note:

“All of our auto parts are intended for Left Hand Drive USDM vehicles and might not have been tested on Right Hand Drive platforms. If your vehicle is Right Hand Drive, please do your research prior to making a purchase to ensure the part is correct for your specific vehicle.”

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Blower Motor Resistor (0:41)
    • Open the glove box
    • Push the glove box to the side and pull it out
    • Remove the two Phillips head screws from the access panel
    • Pull off the access panel
    • Disconnect the blower motor resistor wiring harness
    • Loosen the Phillips head screw from the access panel clip
    • Turn the access panel clip out of the way
    • Remove the two Phillips screws from the resistor
    • Pull the resistor down and out
  2. step : Installing the New Blower Motor Resistor (1:56)
    • Push the new blower motor resistor into place
    • Insert the two Phillips screws into the resistor
    • Connect the resistor wiring harness
    • Turn the access panel clip into place
    • Tighten the Phillips screw in the access panel clip
    • Push the access panel onto its clips
    • Insert the two Phillips screws into the access panel
    • Push the glove box into place
    • Close the glove box

Tools needed for replacement:

    Screwdrivers & Related

  • Phillips Head Screwdriver

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2000-2006 Nissan Sentra Blower Motor Resistor

This part replaces:

  • OE # 271506Z500
  • Standard Motor Products RU-369
Part #: 1AHBR00022

How-to Video:

(03:54 min)