This replacement tail light is just what you need to get your Nissan Altima in good looking form again!

Specifications:

  • LH (Driver Side)
  • Clear turn signal
  • Direct bolt on
  • Built to strict quality control standards
  • Replaces dealer part numbers: 26555-0L725, 265550L725
  • Injection molded plastic
  • Department of Transportation (DOT) and Society of Automotive Engineers (SAE) approved
  • Bulbs and wiring not included
  • Correct for 99 SE models from 1/99 Production Date

We have noticed that there are many inferior quality Tail lights on the market. We have researched other tail light manufacturers and are only selling what we believe to be the highest quality, best fitting, aftermarket tail lights available. So don't be fooled by cheaper made imitation Tail lights. Go with superior quality!

This Nissan Altima tail light makes a great replacement and has good cost savings over a dealer unit.

Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Light uses same wiring as the original assembly, providing easy, trouble-free installation.  No cutting or splicing required.

DOT and SAE Compliant

DOT & SAE compliant: meets federal regulations for on-road use

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

  1. step : Removing the Taillight Assembly (0:53)
    • Pull back the trim.
    • Remove the four 8mm nuts from the back of the taillight.
    • Disconnect the harness.
  2. step : Replacing the Bulb (1:25)
    • Twist out the socket.
    • Pull the bulbs out.
    • Push the new bulb in.
    • Twist the socket back into place.
  3. step : Replacing the Taillight Assembly (2:01)
    • Connect the harness to the light.
    • Line up the taillight and press it into place.
    • Replace the three 8mm nuts.
    • Put the trim back into place.

Tools needed for replacement:

    Ratchets & Related

  • Ratchet

  • Sockets - Metric

  • 8mm Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1999 Nissan Altima SE (Built After 1/99 Production Date) Tail Light Driver Side

This part replaces:

  • Partslink NI2800143
  • OE # 265550L725
  • DEPO 315-1929L-US-SR
Only 1 left in stock
Part #: 1ALTL00215


How-to Video:

(02:59 min)